Cool idea with the ruber band holding the wires on the y axis, i will put this concept on my 840 machine aswell :)

Die beste Investition für meine D2 840 . Vorher musste ich immer sehr langsam fahren ,weil die Y Achse ständig Schrittfehler hatte. Nun kann ich das 3-4 fache fahren. Bin sehr zufrieden. 🤗

Can you show a photo of the circuit board with all wires in place - I seem to have a few missing, or possibly in the wrong place. I have empty slots for 'End Switch X/Z'

Thanks for the instruction. I had only the problem that 1 hal sensor cable was to short…

Very informative video, thank you. I'd like to ask if I buy the performance kit do I need tto buy a new licence for the controller as well or does it work with my previous licence?

great many thanks

It says on the web shop it is only for D series V.2 but I have v.1... Is it still possible to add two motors?

If I am cutting light materials like foam board and 1/8 inch plywood... is this upgrade needed?

Does version 1.2029 of UCCNC work with it?

bought a 4000 euro cnc to see now that i have to buy a extra performance kit i the hope that it works / i trusted stepcraft butt its a lot of money for a hole lot of nothing than the laser of 3watt for 559 euro its a ripp off

ugh should of got it when it was in stock

Don't see this on the website. Is this kit an option, add on or what?