Thanks alot! I have always had a hard time with the low tones, and I had exatly the problem with screw, and a small leak. Now it is much easier.

You, sir, are a hero. I recently dug out my old alto sax that has been stored away for 30 years and it felt completely unplayable. After watching your videos it is once again in working order. Thank you so very much.

This is a good video. The sticking G# pad can be real pain, because it can hit you without warning. Being closed when the G# key is not pressed, including all the time when the horn is not in use, it can almost glue itself shut. The video advice is right. Also, a new pad is a good idea. I had a saxophone on loan that did that all the time and I wasn't able to fix the problem because I was traveling. An emergency fix is to carry some baby powder and Q-tips in the case. Each time, before playing the horn, I used a Q-tip to put some powder on the pad. That worked until the next time the horn was used. It is nice to have an articulated G#, because it makes trills easy, and the right hand keys close the G# pad. The standard clarinet does not have an articulated G# (C# in the lower register). This avoids the sticking pad problem. When you press the G# key, the pad is forced open. But, an F#/G# trill is awkward. The "full Boehm" clarinet (not common) has an articulated G#, and would then have the same problem as on saxophones. I prefer not to have articulation. I once saw a picture of Jackie McLean, and he had a rubber band on the G# pad, going around the bell, to make sure that the G# pad opened.

I used the q tip method and it worked like a charm thank you

Me (and my saxophone) thank you. I was about to throw something but crisis averted thanks to you!

Thank You so very much! I have spent almost 100 euro (servicemember in Europe) having technicians look at my brand new sax and buying repair books. The last minute and a half of of your video and 1/4 turn on that screw fixed the issue that had been annoying me for months. Sincerely, thank you.

all these years I never knew that.. Thanks MSgt!!!

This is great ! Many thanks !

You are very welcome.

I love this man

This series is such a great resource.

Thanks for your service and tips!

thank you so much!

i like this. It is very educative. Keep on the good job.

God bless America !! you save me .thanks :)

One thing I find helpful for preventing sticky keys is getting key paper and cleaning the keys that are sticky or start to get sticky everytime you're done playing. You can find key cleaning paper that soaks up the spit under the key pad wherever you get you're reeds, or online

Great tips. Thank you

Great job

Wow! I think you helped me figure out the problem to playing low notes! B and B flat.

It's true that the g# key sticks. Sandpaper is interesting, but I learned to use cut strips of coffee filter paper put between pad & body, especially when session over and pad is wet. The technique is to put paper in and put some medium pressures on the pad with thumb and usually that gets the wet goo out of the seating area. Once that channel in the pad is cleaned and dried the horn can be put away. Trouble with sticking on other pads does respond to same treatment. Do it and pads won't stick. Ever.

Fantastic information in regards to that G# adjustment screw. I know a lot of guys like using thread-lock on these, if they're loose. I've found that clear coat nail polish works just as well, and is easier to remove. I'll have to try that synthetic leather sheeting for sticky pads. Thank you so much for your service and information Sir.

Great and very useful comments. Excellent presented.

Great vídeo thanks your videos are very helpful

Absolutely amazing. A problem I've had for ages with my sax that can be fixed with the turn of a screw. Thank you!

If you must remove the lacquer, it's recommended that you see a qualified repair person. Products used to remove lacquer can damage your instrument if not done correctly.

I spent $125 for low key pad adjustment (and also replace a couple pads), but now I know how to adjust those lower notes. Thanks for the tip.

Thanks! Just what I needed to know!

Great instructional design - on all of your videos. A+ Thank you!!!

hey man thank you so much at school my teacher won`t be back for a bit to ask her about it but i saw this and helped me alot so thank you

Looks like a Selmer Mark VI circa 1971.. like mine :-) Thanks so much for these great videos.

Wow I just did my first sax repair!! G# was sticky and was wiggling when I used low C#, B, Bb ;) I'm gonna be the hero of low Bb again, thanks Major Sergeant Baron!

I've found that using a leak light while adjusting the G sharp screw gives me the best results.

That was really useful! Thank you very much!

Key Leaves is the Answer. Use Key Leaves Pad Saver. I use Key Leaves for all of my saxophones. It keeps the G# pad and other pads open so they dry out. No sticking.

Cleaning the pads with hand sanitizer is a good tip. That said I wouldn't ever use 600 grit sandpaper especially on a pricey vintage saxophone. For example, my horn is from 1949--if people kept sanding down the tone hole for 60 years, it will change the tonehole height. The pad is a wear item and can be replaced. Once you sand off metal--however minute--that metal can never be added back again. Maybe 1000-1500 grit, but 600 is too coarse I think.

I was about to throw my sax through a wall, but thankfully, this video exists

THANK YOU

Thanks helped me unstick my bis key

Informative, especially about the bell keys. Years ago l was playing a solo at the schools Christmas concert and the g# stuck and it sounded dreadful..... that was over 50 years ago.

i like these and i learning to repair my own saxophone

Wow! Thank you so much

Hi - great clip which shows real problems and their solutions. How do you manage to find the right korkthickness of the d,e,f to f# connection bar (behind the shield opposite to d,e,f) in correlation to the f# pad tightness? Thanks for an answer...

got mine back from the tech, some new pads, etc---entire horn dismantled and now a few weird issues. He is gracious enough to allow me to come back for "tweaks" after a month or two of playing, so maybe be can look at this key? I wonder if I should try myself. But I own a vintage Mark VI...are their consequences to tightening too much, say past the point where the key stays properly closed?

yep. back in the eighties i wasted alot of money sending my sax in for G# service. thanks for sharing

thxxx

wow!! tkxxx

Thank for the vid. be lucky.

Yea my g sharp key does that. But now I think the same thing is happening to my b natural (first finger left hand) do you know any keys that may be getting stuck for that note. Because it’s happened before I just forgot which pads move when playing a B.

I need an advice. If the D and the C don't play well, only when the octave key is activated, how can i fix that ?

Post a link of the Ultrasuede plezz

Thank you, so much. Fixed the g sharp key in seconds with the q-tips. How about that

The G# is prone to stick because the springs are often too lax. The spring that raises the cover must be strong enough to open it positively, and the spring that closes it must be strong enough to overcome the other.

I bought my sax online and the lower three keys ( right hand keys) came out stiff keys. Any recommendations besides returning to fix them?

thank youuuuuuuuuu

Awesome! I bought a second hand shitty sax and that specific key was unusable. Thanks a lot!!

that articulated G# is the key, mine has no cork and is rattling. Can you show us how to or the best way to remove and put in new pads?

Do you have any videos concerning sax keys that stick up ?

Hey man do you have a video regarding advice on bent posts that have dented the actual body of the sax. Whether or not to try bend them back etc. ? Thanks your videos are really good and helpful.

Thanks for the cool tips but be careful, your neckstrap ring seems to be almost completely broken trough!

the dollar bill ruins the pads

Genial.

What brand of precision screwdrivers do you use?

Yo! 2 questions: 1. Does Dale play sax? 2. What is a cheap alto that I could get?

i got a high joint C pad that is totally new and sticking badly ... cleaning doesnt work as it look clean... cleaning tonewhole doesn;t help either. maybe its the waterproof coating that sticks to much .. i don;t know. what shall i try?

Whats the material called? Ultra sweet?

Die klebenden Polster stehen meistens in Verbindung mit einer Übersäuerung des Körpers (ph-wert messen) und möglicherweise auch mit einem Candidapilz im Mund des Musikers aufgrund der Übersäuerung! Es sollte auf alle Fälle geprüft werden ob der ph-wert des Musikers 7,0 oder aber im sauren Bereich liegt!! Solange der Musiker seinen Körper übersäuert hat wird das Problem der klebenden Polster nicht behoben werden können! Josef Altsaxplayer from Austria

Have you tried using Key Leaves to stop sticky key pads? I saw someone mention it down in the comments and I also think that these things are great. If you use key leaves, I don't think you will ever have sticky pad problems!

Sir, any tip on removing lacquer off saxophone...thanks

what should I do if that key wont close naturally? When I go to a g natural it only plays g sharp?!?! Help Please!!!

I used the purrell on my mark vi, ruined it. Thanks man....

I use paper all the time to clean out keys.

This dud is a mirical worker!

HOLY SHIT

I started using Key Leaves and don't need these fixes anymore. It just leaves the keys open to air dry clean and I don't get that sticky buildup growing on the pads. I highly recommend them. KeyLeaves.com

Use pad paper

スウェッジプライヤー

Mouthpiece screw

Completely unrelated foreigner question: Why is the flag on his arm inverted?

marines break everything.... im afraid of @#$%^ my alto more .... D= fix it for me... haha

Why? Do you think it'll play better? A myth.

the camera man vere bad and you vere kwekly

G#, low note squeek (Eb, D, C). dude! you're like a saxophone Sangoma! you tell me my problems before me I mention them (www.gumtree.co.za/s-sangoma/v1q0p1)

600 grit sandpaper is too abrasive! Never go more coarse than 1000 grit. And even then be gentle Marines can fight but they don't know everything.

This would be a lot more helpful if the guy would slow down and stop fidgeting with the horn. The camera work is lousy. You can't see half of what he's talking about.

Oh man, over 10 minutes to say how to stop sticky pads, he could have done that in a minute flat. I guess it beats him being ordered to clean the toilets :-)