Stihl MS170 No Start - Initial Diagnosis

Рет қаралды 16,372

Жыл бұрын

No start scenario on a Stihl MS170. It was out of fuel and started after an external fuel source was supplied.
If there is still a hard to start scenario later on the likely culprits would be fuel filter and fuel lines, along with stiff carb diaphragms.
These along with some other maintenance parts will be replaced on the saw in a later video.

Пікірлер: 6

@Super-Dave-Outdoors Жыл бұрын

This is a bad how to video. I was operating based on what the customer told me but they arent always right. I've had 4 or 5 of these brought to me because they wont start and all but one has been the owner not knowing how to start it. I have another video on how to actually rebuild these carbs but diagnostic procedure should be check for spark, compression, and fuel supply to engine. If you have all 3 and it still wont run or runs poorly then it is likely a defective coil that lost proper ignition timing, a contaminated or blocked fuel system, or an air leak.

@69kaveman Жыл бұрын

Good job! Keep-em coming.

@pieinthesky4106 Жыл бұрын

An empty fuel tank is a obvious indication as to non starting and how to proceed. In fact that's the first observation to make.

@Super-Dave-Outdoors Жыл бұрын

Yep, this is a bad how to video. I was operating based on what the customer told me but they arent always right. I've had 4 or 5 of these brought to me because they wont start and all but one has been the owner not knowing how to start it. I have another on how to actually rebuild these carbs but diagnostic procedure should be check for spark, compression, and fuel supply to engine. If you have all 3 and it still wont run or runs poorly then it is likely a defective coil that lost proper ignition timing, a contaminated or blocked fuel system, or and air leak.

@gusm5128 11 ай бұрын

You didn’t show if it will start on its own without priming it

@Super-Dave-Outdoors 11 ай бұрын

I pinned a comment that gave a summary about why this was a bad video and included proper diagnostic procedure. Due to the design of the fuel system on this machine the unit will not stay running if it only starts after providing an external fuel source. The issue on this one was stale fuel and a customer that had forgotten proper starting procedure. I have another video on how to rebuild the carb on this saw if that is information you need.