The real version of that one guy with the straight piped civic at 3am…
@Fmc_Devil Жыл бұрын
Let’s get a better look at those welds tho
@LosMoney215 Жыл бұрын
Go check out my other short videos you’ll see my welds
@aragrox11 ай бұрын
Clean, If it was mine I would tuck it in a little more for ground clearnance.
@SFMCOLLECTIVE10 ай бұрын
Looks good I can see your bender needs maintenance though as the bends are starting to notch and crush a bit .
@LosMoney21510 ай бұрын
True, the bender was replace it’s been the same bender since 1980 when the shop first opened, do the dies was warped only happens when bending 3inch but everything else bends perfectly fine, good eye for catching that
@SFMCOLLECTIVE10 ай бұрын
@@LosMoney215 No worries just figured I’d throw that out there for ya. Job looks great tho none the less and we both know them benders ain’t cheap so I get it. I’m assuming your bending 2.5s more than 3s anyway but what do I know really depends on what cars your in. 😆
@user-kv7np6ww2h9 ай бұрын
i can hear and smell this video
@LosMoney2159 ай бұрын
Lol smells like E85
@ih8atm10 ай бұрын
How much did you charge for that? About to have the same job done at a local shop and was wondering if you could give me some insight
@LosMoney21510 ай бұрын
I charged $250 I use a entire stick of 3inch pipe
@LosMoney21510 ай бұрын
Some shops might charge more or less but that’s around the ball park you should be looking at
@gurjindersingh19910 ай бұрын
Are u using the flex joint ? If you arent whats the reason not to ?
@LosMoney21510 ай бұрын
I added a 3inch flex after and the down pipe also have a flex
@gurjindersingh19910 ай бұрын
@losbullykings215 very clean work bro
@putterptheeravas22182 ай бұрын
whats diameter?
@LosMoney2152 ай бұрын
3 inch Pipe From The Turbo Manifold To The Back Of The Car
@user-jq5ho9wm7q Жыл бұрын
Stock headers boss?
@LosMoney215 Жыл бұрын
Well the car is turbo so it’s coming off the down pipe from the turbo