No video
Turkish Metal Spinning with John Akkus
Рет қаралды 68,914
Күн бұрынJohn Akkus demonstrates his metal spinning technique. See John and his demonstration live at the Fall 2010 Sugarloaf Craft Festivals in Timonium, MD, Somerset NJ, Oaks, PA, Hartford, CT, Chantilly, VA and the November show in Gaithersburg, MD
@AlainAngulo-xg7gt 6 ай бұрын
Excelente trabajo.
@n2dabloo 12 жыл бұрын
Thank you sir! Very informative.
@ArnoldsDesign 13 жыл бұрын
@turbotonic27 No explosion, but plates have been known to get thrown from the lathe before the plate is "seated" against the form. I do spinning too, and it's not bad. It's just tricky to get the technique down without the metal wrinkling.
@walterhebertsilvagonzales232 4 ай бұрын
Hello, does anyone know web addresses of lathe manufacturers, I would appreciate it.
@yenersevim990 3 ай бұрын
Selamünaleyküm cihan usta ben izmirde yasayan metal sivamaciyim orada is durumu nasil calisabilirmiyim.tesekkurler
@AlainAngulo-xg7gt 6 ай бұрын
Se puede hacer un tubo de 10mm de diámetro y 12 de largo por el método de repujado le agradezco sus ideas y opinión.Suy cubano y aquí no hay mucha cultura de este trabajo gracias de antemano.
@PTinvest 5 ай бұрын
How to calculate sheet metal shape of the projects
@ercyil7827 6 жыл бұрын
I m not sure, his name is not John Akkus, i think his name is Cihan Akkuş
@user-go5uq7ix7i 6 жыл бұрын
عمل ممتاز يمكننى تنفيذه بسهولة
Eugenio Monesma - Documentales
Рет қаралды 3,5 МЛН
Excell Metal Spinning Ltd
Рет қаралды 10 М.