Pete - Here's a little hint on how to glue - Put the glue in the hole and not on the part. That way the glue gets pushed into the hole instead of oozing out onto the painted surface. Same thing when you're applying glue to the rear fuse section. No cleanup needed!

You made a mistake on the machine gun barrels that go on each side below the cockpit. They are supposed to be flush with the sides since they only shoot forward to the front of the a/c.

I am getting one.. I already let the price go up a hundred dollars while I vacillated. Thanks for the video Pete!

One thing I do when assembling, and gluing parts together, especially parts this large, I put the wires through a plastic, or rubber tube, and insert it through the fuselage, so when you join the halves together, you aren't getting glue on the wires. Then afterward, you simply slide the tube off of the wires. You ended up breaking the gun mount when you pressed the gun into the clip. Great build, and I will be getting one soon.

Great video! Nice to see the B-25 remembered. Looks like a quick easy project (I think I'll convert mine to the B-25 H though)

Hi I do have to say. I have about 7 planes from Banana Hobby and they all fly very well. Check out my flight on the p51d and the new FMS pitts. Only one thing on a motor and they replaced it. Pete like I always say keep up the good work.

Man that is one BIG war plane! Nice video and great camera man! Pete have a great one and know you guys are doing a awesome job for us!

I enjoyed watching you build this model sadly i could never afford to buy one now, but it was very interesting none the less

good build only thing wrong. those guns on the sides should be facing foward lol. thats so the pilot can go on straffing runs after dropping his bombs. awesome plane cant wait to get one! thanks forthe video keep up the good work.

Nice build. Perfect plane for the beginner in my book.

Wow. 2/3rds of the comments here look like they were written by 12 year olds. For some of you the most important point was to bash the camera man? Wow. Good build video. I would have liked to have seen more about connecting the electronics wiring, but I am much better prepared to build mine after watching this than I was before. Nice job and thanks!--Jim

Use shrink tubing NOT electrical tape to keep the extensions together!

The main cannons should be facing forward not at an angle

Awesome build.

GREAT JOB PETE

pete installed the 4 pilot controlled forward facing .50 cal. they should be flush with the plane not facing out like there are 4 more waist gunners using them.

A good idea would be to wear gloves then you can wip them off and not get glue on the plane when assembled with clean hands also zip ties and lum work good for cleaning up the wiring part of things.Very nice kit that is for sure 5 stars.

Nicely done Pete, However you did install the side blister guns wrong, no bigge as most of us know how they are supposed to be. Still working on mine, but doing a detail repaint as it goes together

Fantastic build Brakes are you kidding me lol nice. They could take it one more step being it is a 3 peice wing it would be complete if they added fold up wings also that would make it the sweetest thing along with all the other things it has.

Thank you. I enjoyed watching.

Hi ! Can you memtion about the CG ? Is 90 mm OK? I find it is difficult to balance. When on balance scale, the plane can drop either way, tail or head. No exact point to stand still.

when he is describing the hobby knife(1:58) a small red box pops up for a second it is annoying me because it I don't know what it says, it doesn't render properly when it blow it up bigger. does any one else see it

Have just finished my build. Now I'm ready for the maiden flight. Can you Pete, or anyone else, let me have the recommended control surface settings for Elevator, Aileron, Flaps & rudder. Also any mix settings.

I am in a place where he nearest hobby shop is about 1,000 miles away . So , I would need a complete package . batteries , radio , chemicals . How much and do you ship to the filippines ?

Hey banana!!! I'm Mexican but I'm going to visit U.S., thought about buying one but I am beginner rc airplane and never flown one and because I know that I recommend for rc plane to fly them get started

Cool. Load it up with a go pro in the cockpit and another pinhole camera in the turret. And light up the skys. With a fvp. One thing though. Fix the side machine guns. Those are supposed to be flat against the body. They only point forward.

I probly whatch this vid twice a day. Nomater how many times i whatch this vid of this amazing warbird i cant get enought . I'm a true hobbiest not a poser as i call it. A poser isa flyer only nothing to do with building just flying. I'm in the middle of scratch biuld and are redey designing a nother. I love to create flying is the award for the hard work.

Great video on your B-25 build. I noticed you have a tool bag/box on the bench in back of you, do you carry that for sale? If not where can I order one. chas

I like it..!!! I'm going to buy one.

You should also use fuel tube on the clevis to keep the clevis from coming off the control horn.

I think you did a nice job

boy, is this guy ever a chatter box,must be the magnets in his ears

interested to see the brakes at the field

good build demo

Hey dude does this b25 Jay Mitchell remote control come with a battery

This plane was given to me by a friend but did not have the manual. I'm looking to find out what the CG is on this. Doesn't seem to be mentioned in this build video. Thanks

I'm confused you show the props turning one way and the instruction book shows them turning another way which is correct or does it matter

and you fixed it. good!!

you can put FPV camera inside the cockpit and how to install FPV camera inside the cockpit of B-25?

Are use a spectrum radio, could I build this plane with a spectrum receiver with SAFE?

Pete it would easier if you get a wire coat hanger and undo it and tape the wire on it then you can run it through there very easy

Thats grazy why do use Epoxi clue , take epo clue , or Ponal express ! Salute from Austria !

What flight time do you get on that plane ? And a battery?

Also does it come in shiny silver or that chrome covering you see on some planes???????

The only problem is he is doing a receiver ready and not a kit version which they sell. The detail that comes with running all the many wires not only in the wing tips but the center section with the ESC's and wire harness. surprised that they did not use quick disconnects for the wing tips.

gran trabajo

you broke the connector for the canon at 1:26:35 how did you repair it??

carefull pushing the tail on to the fus. pete flexed the fus as he pushed it on. dont wanna snap it now ay.

you do not have a démo ?

You can see at 1:02:36 the alcohol has marked the paint where the tail was glued on.

so is he building the arf or the kit

There has never been a modeler that hasn't had Epoxy on his hands .

Nice plane :D

This plane is a beastl

Where could I get one of these?

Hey banana hobby with your build reviews are you building ARF or KIT. Either with this one or others?

Pete´I hope by now you know better where the fuselage blister guns should be pointed to. I've enjoyed the review.

Better check on that because they do ship outside the US.

Солидно,статно,добротно...супер!

just got b25 will build when it cam will CIVE feed baek

Forward fuselage machine guns should face forward, not off at those crazy angles. Have you never seen a picture of a real B-25?

hey bro did not hear that happens to my iPad and I can not go to banana hobby store. if I could put the link of these planes rc? please and thank you very much for answering

I can see you are familiar with balsa and ply cutting, gluing, sanding, covering, painting, engine or motor instalation and related systems, radio instalation and so one. All the hard work. By the way, I probably enjoy as much as you too watch this, but what I see is assembly, not actualy building.

Right i meant assembly not sctach build is what im working now as well as die cut plane pt20 great planes. The scratch build plane is going to be a f4u cosair build to identical scale will be 100'' wing and 80'' fuselage. When i get somre drawings on paper ill e-mail you see what ya think. Thanks for contact me pete.

do you guys sell a B-24

Head tracking FPV Camera in the Cockpit would be nice would be very nice...

epoxy washes off in warm water if you do it before it dries

A plane with this size should have all detailed landing gears made of metal, not plastic. Specially the nose landing gear!

couldnt you have threaded the wire before joining the two sections at 48:20

I am from India where can I get this model please

they should have used screws on the main wing as well... easier for maintenance... and replacement...

So... how much for a model like that?...

that's about 1/24-1/18 scale I'd say

oye yo tambien estoy haciendo uno, pero no con tanta calidad porque no se de aviacion mucho y ademas no tengo los materiales necesarios quedo muy bueno,

very good build video, but that camera could be better. very shaky, and also bad autofocusing degrades image. you should use one camera on stativ to record table, and maybe second camera set up to record hands (i mean something like sparkfun have, in product showcase videos)

you should change the title of the Episodes to something like: 'Bananahobby's building Guide - (the name of the aircraft)'

I want to buy it please help

Make the build of the A-10 ( if u have , give me the link)

Is take 1 hour to build that whoa that fast

go to a hobby store and ask about a Radian or T-28 trojan

Dropping candy for kids like the candy bomber. (It's a book)

Sir i have more than 45 Aircraft ranging from Electric to Turbine and Have many Championships under my belt. We have many people including me on my Flying Field who will have the same opinion about Banana Hobby..

All the elec. planes i'v seen on youtube have problems from fires bsd escs motors lipos. All the nitro gas and turbine have had mainly piolot mistakes . They have had more fly time then elec. planes....soni rest my case.

Am I the only one who noticed the red thing at 2:5

You put a stand for the side cameras but not the main camera Why? also you need the camera to stop blurring

YOU NEED TO SPEND MORE TIME ON HOW TO CONNECT THE WIRERING

我以為是自已做的！（ 現在有現成 可以買得到！）

There is no camera man he is controlling the camera with a remote

Why does he have magnets in his ears?

Banana Hobby is a store front, not the manufacture. They sell good products at a price in line with others. My purchase from them came on time, intact and flew well. My EDF from them is a year old and has over 40flights with success. Don't blame Banana Hobby you cannot fly...

haha at 1:58 a red boxs pops out

Nice plane Man that boil on your nose looks nasty at 1:01:43

Where in god's name did you find this GIANT Mitchell plane??????!!!!!!😮😮😮😮😮😮😮

i want genesis power!!!! too bad u no longer ship outside the usa. how much $ r u guys losing?

Good information but I was getting sea sick with all the camera movement. Felt like I was on a boat.

If ya'll a wondering were pete is he's working for aerobeez.com

Mr Chau its Mr chau!!

im betting this was recorded on an iPhone

So, anyone have this? Interested in quality, landing gear holding up, etc. For the $$$ I'm always afraid of their planes...

Vertical stabilizer held by one screw?? C'mon Pete, surely you can improve on that.