Super Duty E Locker Swap! (Sterling 10.5 / 10.25)

Рет қаралды 3,614

2 ай бұрын

Today we take out the garbage limited slip differential that came with the one ton axles I installed in my 2010 Toyota Tacoma, and swap it for a factory Ford E Locker from a 2011+ F350.
These E Lockers can be found cheap at junkyards or in my case Facebook marketplace and will work in any Sterling 10.5 or 10.25 axle.
Snail Armor Panel: snailarmor.com/dirtgarage
Support Dirt Garage by purchasing our Merch! - www.dirtgarage.ca
Brought to you by @ Alpine Toyota - alpinetoyota.com
10% OFF YES WELDERS: yeswelder.com/?ref=z9n5g70h
10% OFF YANKUM ROPES: yankum.com/?afmc=DirtGarage
INSTAGRAM - / dirt_garage
Music Licensed @ Artlist
Find music for your videos on Artlist! artlist.io/Clinton-279876
Business contact: Dirt.Garage@outlook.com

Пікірлер: 22

@JW-cn6op Ай бұрын

The thick cut gears are made to run on a 3 series carrier so you don't have to replace the carrier when going to lower ratio that would normally use 4 series with a normal gear set.

@abpsd73 Ай бұрын

That's what I was thinking, a thicker ring instead of having high/low ratio carriers.

@vmoney9106 Ай бұрын

Never mind the locker, loving the hair!🤟🏼

@Gerry-K Ай бұрын

Yeah Joe Dirt, Canadian style!

@mountainjeepmike Ай бұрын

Nice upgrade!

@travischapin886 Ай бұрын

I have a 2016 F-250 with the E-Locker, works great.

@monette44 Ай бұрын

Nice shaft.... a little twist for funzies 😮

@nemesis851_ Ай бұрын

Can tell this was a research project, before diving in

@caseyh7826 Ай бұрын

Thats sick, i love cheap performance parts lol. Although it looks like an antiwrap bar would be helpful. Looks like you were getting decent axle wrap.

@DirtGarage Ай бұрын

There is a anti wrap there 🤣 But what you can't see is it ripped off the factory crossmember.. Gotta build a solid crossmember for it

@caseyh7826 Ай бұрын

@@DirtGarage all those toyota horsetorx twisting shafts and ripping brackets 😆

@DNance_1 Ай бұрын

About to do the same. What gauge wire and thread size for the cable gland did you use?

@nemesis851_ Ай бұрын

I wonder if the solder, heatshrink, connector, seal, wire coating is temperature rated to the gear oil temps

@nemesis851_ Ай бұрын

I see in the thumbnail solder was external to diff

@jameshall4385 Ай бұрын

Your "new" used locker looks like the previous owner didn't install the pinion correctly and it self clearanced on the carrier. You might want to keep an eye on that

@DirtGarage Ай бұрын

Yeah it had a crush sleeve failure I was told. I'm well aware of that 🤣