Just installed a swing case tool box in my f250, just a little review of it
Пікірлер: 12
@jacobc57572 жыл бұрын
Why not put one on both sides? Is that ambidextrous to either side? @Buck-n-Gun Outdoors
@buck-n-gunoutdoors66222 жыл бұрын
Jacob C i plan on it just wanted to see if i liked it first, so far so good
@buck-n-gunoutdoors66222 жыл бұрын
Oh yeah its not ambidextrous you got buy driver and pass side
@daoyang89194 ай бұрын
How has this swingcase held up?
@buck-n-gunoutdoors66224 ай бұрын
Thanks for watching and commenting, so far so good i have had no problems with them, the only thing is if i take my truck through a car was just a little water will get in them, other than that all is good, please like, share and subscribe thanks
@MrScott123672 жыл бұрын
I’m looking for one for my 2001 ford ranger edge 4x4 with a 6’ flare side bed. Do you if anyone else has put one in the same generation Ranger’s. The inside of the bed of the truck is 16” inches. I can modify or fabricate the mounting brackets if necessary
@cabsrb002 жыл бұрын
Scott Owens thanks for watching and leaving a comment, I'm sorry but i can't help you, i don't know anyone but im sure someone has done it i personally don't know anyone.
@MrScott123672 жыл бұрын
@@cabsrb00 thank you for the information. I hope someone else takes a look at your video and read some of the comments, maybe get lucky and someone has done it with an older truck. ✌🏼
@cabsrb002 жыл бұрын
@@MrScott12367 i wish you the best of luck buddy, God bless take care
@brodavidb Жыл бұрын
Latches fail. Latches fail. Latches fail. I've been through 4 of these. All fail.
@buck-n-gunoutdoors6622 Жыл бұрын
Hey thanks for watching and commenting, so far i haven't had any problems but if the latches go what i feel prematurely i will post a video and let ppl know, thanks