In this video I explain symptoms of a bad timing tensioner. The timing sysyem should be inspected when you hear rattling noise from the engine, low power, limp mode, misfire, poor acceleration, low compression... Top5autorepairs
Пікірлер: 10
@fawzisdudah85115 ай бұрын
Thanks for the great videos you post. No fluff videos. Thanks.
@Debreizen9 ай бұрын
Thanks mr ❤
@Atonement-Ай бұрын
good stuff
@schlick93ifyАй бұрын
My 2007 dodge ram 1500 3.7l V6 it has a rattle when I take off & sometime when it’s idling down coming to a stop, it kinda sounds like thin metal rattling, I’m hoping it’s not my timing chain I don’t think it is because my truck runs great its super smooth at idle you can’t even feel it running & it’s got plenty of power it’s not sluggish at all, I’m trying to figure out what this rattle is, even when I remove the oil filter cap there no noise coming from inside the motor & there’s zero blow by, I’m just worries because my 2010 Silverado developed a lifter issue so I had to park it & buy this truck I use it for my auto glass business, I don’t wanna have to tear this motor down too & repair it I’m going to fix my Silverado soon so I can start driving it again & keep this dodge as a backup truck
@samuelhepburn263626 күн бұрын
A mechanic changed my son's 2000 Honda accord water pump , afterwards it couldn't start (the engine wouldn't turn over), then he changed the pully tensioner (messed that up) , is there anyway to tell if the valves are messed up since the car can't start.??
@gotsu217 күн бұрын
I recorded this from the subaru impreza: kzfaq.info2VhEvk3qpn0?si=sjerSwxaiwmGSRQf Or under "Shorts" in my channel with descriptions Do you think it's the tensioner failling/timing chain stretched? Thanks.
@kingmeh3317 ай бұрын
My vehicle will start up idle and then cut off after a minute or so😢
@idrismuhammad64696 ай бұрын
What if it's too tight?
@andreasnilsson683420 күн бұрын
Id like to know too
@fm476519 ай бұрын
Can I send you a clip Of my car on startup, It sounds like a pulley, But not sure if it’s a dual mass flywheel issue