Tamd 60c . Taking out injectors for repair with homemade puller
Пікірлер: 19
@thorstenluders77712 күн бұрын
Great! Thank you for this Tipp.
@skunkjobb4 жыл бұрын
Today, I finally began to remove the injectors. I found out that the thread in the top of the injector, where the screw for pulling them out shall go is fine thread M8x1,0 mm. I only brought M8x1,25 so I'll have to continue another day. Couldn't find any M8x1,0 screws at Biltema or Bauhaus either so I when I got home, I cut a thread myself with a threading die in the non threaded end of a partially threaded M8x1,25 screw. Next time I go to my boat, I think it will work.
@Birchwood3204 жыл бұрын
I use old bolt That holds the return line. Cost nothing at volvo dealer
@Birchwood3204 жыл бұрын
Her eg skulle svare. Har du nye dyse spisser. Har kontakt med en Kina mann. 10 for en billig peng. De solgte bare minimum 10. Men er Kina varer
@skunkjobb5 жыл бұрын
Very nice, I will do that soon. Maybe I make the tool by bending a flat iron into an inverted elongated U instead of a pipe, or a pipe with a larger cut out on one side. Then I can leave the fuel nipple on the injector but I guess the nipple comes loose easily so it doesn't matter much.
@Birchwood3205 жыл бұрын
If you take loose the nipple remember there is a flat washer in there.
@Birchwood3204 жыл бұрын
Har du nye dyser? Kan skaffe 10 stk for billig peng men er Kina saker. Har ikke proved dem selv
@Birchwood3205 ай бұрын
No wasn't need for that as long as they don't get damaged
@ralph99875 ай бұрын
Did you replace the copper sleeves at the same time?
@maurizioargentieri13172 жыл бұрын
Very good idea is it working for a Volvo Penta AQAD 41A also?
@Birchwood3202 жыл бұрын
Suppose it does.
@thorstenluders7778 күн бұрын
Can you tell me the inner diameter of the pipe you used as a tool? That would be great. Then I can build one myself. Thanks!!
@Birchwood3203 күн бұрын
Try and messure it. If I cand fint it in all my clutter
@terencecorlette7841 Жыл бұрын
Fuel injectr pump seting
@Birchwood320 Жыл бұрын
What do you think? Injection pump setting is done.
@jackhannan46623 жыл бұрын
What tool is that and where do I buy it
@Birchwood3203 жыл бұрын
I made it. Only a piece of pipe with diameter so ypu don't pull up the sleeve. A old bolt for return line welded to a longer bolt with a nut. Easy made
@jackhannan46623 жыл бұрын
@@Birchwood320 I need one as I need to replace the copper sleeve. I can't get my injectors out. Fancy making one for my volvo penta 2002 . Obviously for a price . Cheers Jack
@Birchwood3203 жыл бұрын
@@jackhannan4662 vell. Not easy right now. Have so much to do.