I have a tt02. I used the stock brushed 540 torque tuned motor, 6 cell nimh battery. And upgraded to a 25 tooth pinion. Right out of the box I was able to get 22.8 mph whith the new pinion.

Nice. Stock tt01 motor on nimh 16mhp. Then on 2s lipo you got 18 mph on the stock motor. Wow and 22mph on 2s with the 12t motor, with foam tires you got 23mph. Next you have to add 3s lipo and 3s lipo brushless comparison.

Them oil shocks make massive difference👍🏻 good luck with your speed build🤟🏻

My TT02 with super stock RZ motor 29 tooth pinion, with 7.4V lipo battery record 50km/h. the consequence is the motor heat up to a unbelieveable temperature that i even cant touch it more than a second.with my finger. i have to take a break every 5 min run

put some ballbearings in it, and test again 👍

I did the same thing with a TT02B and brushed Titan 12T but on 3S. I was able to reach 37mph. 🤙🤙

I am searching for touring track setup for brushed torque tuned motor category

Now I know what to do with my stampedes titan since it’s gone brushless

Hey, dod you go down the brushless route on this tt01? Cheers.

I have the same charger ❤

does the lipo offer longer run times overall also shorter recharge time? I'm not doing speed runs. just backyard club racing.

I'd say 4300 , 4370 kv on 19t pinion & 2s or 3300 kv on 3s geared down too maybe 17t. Think as you approach 40+ mph you'll have the chassis start sliding on you. You can get a different motor mount so you can mount up different pinion gears as well as it's an onroad car you could probably jump up 3 - 4 teeth on the titan 12t no problem for shorter speed runs even higher.

I have a tt02 will I need a different motor mount to run a 550