Tamiya TT01 steering problem fixed

Рет қаралды 7,827

2 жыл бұрын

A checklist to help you diagnose your steering problem on your RC car. I have been having issues with the Tamiya TT01. This issue can also exist on other cars and many of the checks cost nothing to do and some cost lots of money...
some things for you to consider when having issues with steering.

Пікірлер: 19

@BigChuck_1 2 жыл бұрын

All my batteries used to have balance plugs with NO Backshell; Now most all have the larger molded Backshell and I find it gets in the way a LOT! I can certainly see the molded Backshell is more durable, but honestly I don't recall it being an issue before. 😎

@islandrc-duke1972 2 жыл бұрын

Cool RC and great fix

@WellingtonIronman Жыл бұрын

My DX3C went exactly the same way, intermittent loss of signal. I changed the antenna and it was the same. Never dropped, just failed.

@PopalongRC Жыл бұрын

I’m still annoyed about this … my new transmitter is good but I prefer the feel of the old one

@vmddew Жыл бұрын

Nice Tips. Thank you.

@PopalongRC Жыл бұрын

You’re welcome ☺️ good luck

@costa_349 2 жыл бұрын

Hiya, semi related question : The TT01E has the steering system from the TA05. Do you know if that can be fitted to a TT01 as an upgrade ?

@justinhaynes1085 2 жыл бұрын

Great video. My 13t brushed is stuttering until it reaches full throttle and heats up to 80°c and the 60amp ESC to 90°c on a 2s 45c 4200mah. I've checked for load tension along the drive train. Thanks in advance for any help here

@PopalongRC 2 жыл бұрын

sounds like it might be over geared

@naushadsheik1662 Жыл бұрын

Your not geared correctly

@enricomiceli5517 Жыл бұрын

Nobody does it but u can just remove the cover of the balance bale and get it less bulky! Also i put a lipo checker with an alarm of the battery holder so once the battery is in position i stick the balance there and set the voltage i want the battery to reach before the alarm start signaling me. Again this schrews on the deck can be too tight and ruin the steering experience...

@PopalongRC Жыл бұрын

Interesting 🧐

@NorahCIIV 2 жыл бұрын

Bro as you know I was excited to get my TT02, got it today turned it on and it went flying into the wall and now the steeling won’t turn, and it jerks forward without me even touching the controller, I don’t know whether I need to adjust the controller or if I got sold a lemon :( I need your help please respond, my whole day has just gone down the drain

@PopalongRC 2 жыл бұрын

A good starting point would be …. Turn everything off and unplug Make sure servo and esc are properly in the receiver Put fresh batteries in transmitter Turn on transmitter Turn on car Adjust throttle trim on transmitter

@matthewhall1068 6 ай бұрын

And always have your car up on a stand with all four wheels in the air or heck even just remove the tires all together any time your doing a first startup /have been tuning or makin any changes on the car!!Trust me It'll save the paint on the walls in your home and your rc bodys 😂!! "PRO TIP 101" always wear a shirt and never have your car facing toward you after changing things around because it hurts like hell when it comes at you full pin 1st knocking the wind out of you as it smashes you in the stomach Then immediately crawling up and ripping your chest hair out right before coming to a dead stop from superman smashing an upcut into your lower jaw !!👀🤔 Yeah wanna know how I know! Well this one time it was 3am in morning an I was making an last ditch attempt to fix my car for the races an i flipped that power switch an learned me a good lesson real quick !!💯💀🤦‍♂️ 🤙✌️👍🫡

@andyhbo86 2 жыл бұрын

What led you to finding an issue with the transmitter then and what was it? Dodgy pot?

@PopalongRC 2 жыл бұрын

When racing I would turn the transmitter but nothing happened or I would be turning and the car would straighten up for no reason. After fitting the capacitor I was testing the steering when I saw it happening … having already replaced receiver and servo, the transmitter was the next link… Wife also disclosed that she had knocked the transmitter off the shelf a few weeks back which would also explain a few things .

@banderson716 2 жыл бұрын

Why would you double down and give even more money to the corporation who just ripped you off? Savox fan boys make no sense to me. I stopped giving them money the first time they sold me a piece of junk. You just gave them even more.

@PopalongRC 2 жыл бұрын

Never had such a reliable quick responsive servo. Always relied on savox otherwise I would have opted for a different brand. Sounds like you had some bad luck there fella.