Great fun video all should be fun like this 👍🏼

The "interview" and silly music made that informative and funny😂

I'm sold, will be ordering my mount thanks to the vid.

It's awesome to watch how a socket and ratchet work.

OK, so the mount looks good... but why not show the antenna installation as well. Is there room for coax through the existing cabling hole that carries the electric? Nice product though.

Small thing of note: If this is to be used as a mount the upper screw should have a star washer added both in side and out to insure a ground to the body. This is particularly important for CB and HF antennas. Also a star washer on the ground side of any mount 3/8-24 or UHF (PL-259) to the Bracket. Without a decent ground tuning the antenna will be difficult at best.

I came back to look at this as I wanted too change the whole tail light assembly. I can't as I can not find a way to get behind the light from inside the Jeep to put nuts on the bolts that are on the light. there is no access panel. I have a 98 wrangler TJ. but I did buy your CB. mount as you show here.

No silicon or Rust protection for that new hole ?

I was thinking the same thing. I also noticed how clean that Jeep was. Very odd!

More TJ s please!

U CAN WORK ON MY TJ ANYTIME U GO GIRL

You don't really have to put a 4th hole in...

Good video, thank you very much. I caught a Star Trek joke in there.

Can this mount handle a 102" whip antenna and barrel spring?

Now, I haven't pulled mine off and looked. But if it has 3 bolts holding it on, why do you need the 4th?

What flavor is the gum?

10/10 would wife.

Not sure I want to drill a hole in my 42K jeep so it can rust or leak water

Jen is a little wierd haha

The chick with the microphone was super annoying, the rest of the vid was very informative. Now I just need to get the guts to drill out that hole. Dreading it..

What.... Are you saying even a girl can do this? LOL. I wonder where these girls are 9 years later.