In this video we show what is happening when a datacable or other HF signal cable is not properly terminated and
Пікірлер: 18
@BKK-Japan1 Жыл бұрын
Mostly unskilled engineers nobody tries to understand termination resistors even explanations and finally get communication problems. This video is a good solution for them.👍
@sssfhkcoАй бұрын
Simple and easy to understand
@combinacijus Жыл бұрын
Wow thank you. It's really helpful to see it practically
@qzorn44403 жыл бұрын
very nice video... this is a great bench top test that can be very useful on the factory-floor... now for my oscope and function-gen and lets get started... thanks..:)
@tonyzhu45714 жыл бұрын
thks for this excellent explanation!
@leoakirakblo5 жыл бұрын
Thank you for this information!
@JoSmokey2 жыл бұрын
Great video!
@THECOLONEL504 жыл бұрын
Great video.
@bahersoliman49785 ай бұрын
Excellent
@MohsenTM15 жыл бұрын
Good Cool please tutorial other termination for CMOS or TTL CHips ....
@Regimantas_Baublys3 жыл бұрын
Thanks Usefull
@sitecsolutionsbelgium39077 жыл бұрын
normaly for data communication we use special wiring but in industrial sites sometimes we need to connect modbus communication on the standard wiring and then is it very important to terminate the cables with the right resistance
@Anver_Silyaev Жыл бұрын
Thanks a lot 🙏
@EvillNooB3 ай бұрын
good video, but you have not shown it with wrong resistance, what happens if you put 200 ohms? or 500
@sitecsolutionsbelgium39073 ай бұрын
@@EvillNooB , with wrong resistors you could have a breakdown of de shape (square waves), with the correct resistors the shape will be always good
@idavancunha82462 жыл бұрын
Great video! I had to do the same. I used a regular wiring (2x 0,75mm pp) to connect two devices through rs485. Incredibly when the ambient temperature rises to about 28° C, the communication stops. I've put a 220R resistor (one at each side), and the problem was solved. The length of the cable is about 130 meters. How do I see if the resistors I used there are properly? Best
@bertcywayne80512 жыл бұрын
RS485! interesting. Was your termination resistor was between A and B?
@sitecsolutionsbelgium39073 ай бұрын
Test it whit a function generator with square waves and a oscilloscope, the square waves must always have the same shape independent of the frequency , than you have the right resistor.