Testing with a 4" dredge

No video

Testing with a 4" dredge

Рет қаралды 20,549

Күн бұрын

We made up the hill again, doing some more testing, one hole was 2.5m down and working about 4ft of gravel, and the other side was much deeper of gravel, to deep for the 4".....

Пікірлер: 19

@SHODGES69 5 жыл бұрын

You’re pretty good with that pan bro

@12madcow 5 жыл бұрын

Cheers.. should be have done a few now... Haha..

@sharonlewis7638 3 жыл бұрын

Never seen one so clean. Great methodology. 👍

@danidezuger97 6 жыл бұрын

Very nice underwater shots. GG greetings Dani

@billchiles9089 5 жыл бұрын

Man, you need a big 8 inch rig for that bottom. Gotta day though. That 4 inch rig is throwing some serious rock.

@12madcow 5 жыл бұрын

A normal keene box won't be able to keep up that's why we modified the box.. If ya look at the other videos of the 6", you will see what we have done..

@WilliansNunesWSVidros 3 жыл бұрын

Very Good👏👏👏

@poptart8741 7 жыл бұрын

is that a 3 stage box you are using or the single stage box ?

@12madcow 7 жыл бұрын

it was a 3 stage box, now its a single box, 2 pans to clean in up.

@goldpanr 7 жыл бұрын

And is it stock riffle configuration or is it modified with different mats?

@12madcow 7 жыл бұрын

hi.. its a modified box.. hog mats at the top, riffles in the centre and expanded mesh on the back

@MrRATMAN250 7 жыл бұрын

gaday guys great vid,can you buy the 4 inch dredge set up in NZ if so how much are thay mate?cheers

@12madcow 7 жыл бұрын

trademe is a good place to start.. or go online and make your own one. but you will need a claim to put it on..

@bergap1000 4 жыл бұрын

Good afternoon friend, I have been researching this dredge system for some time, but nobody shares the exact measurements for manufacturing! measures like necessary motor, type of pump and measures, injector nozzle measurements ... I would be grateful if you could share the measurements of this project! big hug and success ...

@billchiles9089 5 жыл бұрын

That’s too much gold to be losing from one pan of tailings.

@12madcow 5 жыл бұрын

The pans arnt off the tailings, the box is a modified keene box.. And yes an 8 would be the go in that area, but most of the claim isnt suitable for a 8".. That spot on the 4" was 1g an hour.. But we were just testing before we bring in the larger dredge..

@billchiles9089 5 жыл бұрын

1 full gm an hour is pretty darn good return And my apologies for assuming those pans were from tailings.

@12madcow 5 жыл бұрын

@@billchiles9089 its good for a 4" and the area we were in.. We were only taking the top 1ft off the top, to deep to even try to hit the bottom..