The Barber - Axial AR60 Extreme Shave

Рет қаралды 3,346

Күн бұрын

Explaining how and why I made an extreme shave on my AR60 axle and installed The Barber on it.
There is a quick "how to" at the end of the video.
I have sold quite a few of these and only got one failure that made change the design for a beefier version.
You can find the Barber here:
www.shapeways.com/shops/progr...
You can also have a look at my lower link mounts on another video.

Пікірлер: 14

@greenie43 Жыл бұрын

Nice vid!! 😎👍

@ruftime 4 жыл бұрын

Great designing!

@rcrockcrawler 4 жыл бұрын

Great idea!

@josh6575 4 жыл бұрын

Nice work!

@FunAdventuresImp 3 жыл бұрын

I'll be interested in your product very cool For a comp crawler

@SlavaRC 2 жыл бұрын

🥰🤩💥💯👍

@AgeOrmstad Жыл бұрын

Dream on🧐🤪

@mtkidrc2307 3 жыл бұрын

one thing you failed to share in the "how to" video at the end is the two notches that need to be made on the front face at the bottom. I kept shaving the bottom of mine thinking the interference preventing my cover from fitting properly was from the bottom, when it was actually from the two notches that were needed to be made at the bottom of the front of the housing opening just below the two lowest bearing capture holes. Just an FYI.

@progressive_rc 3 жыл бұрын

Good point. I hope you found that on time and didn't trash the housing.... I will make a remark on the product page and also here on the video description.

@RC_Ira Жыл бұрын

😱😃🤩💥💯👍💪👏👏👏

@mdmtb4807 2 жыл бұрын

Hi, where can I buy a couple of those?

@progressive_rc 2 жыл бұрын

I didn't even realize that the link for my shapeways store was missing! You can find all the versions here: www.shapeways.com/shops/progress-rc?section=The+Barber%2FAR60&s=0 If you need help you can message me here or on FB / Instagram (search progressiveRC).

@mdmtb4807 2 жыл бұрын

@@progressive_rc Hi I need the fat barber for stock locker and gears but I had to flip my front axle to put the diff on the passenger side and then flip my ring and piñon to run a Cheezburger transmission. So I need a covers that are opposite each other. Front axle the ring gear is closer to passenger wheel and the rear is the same closer to passenger wheel. But u make them like that?

@progressive_rc 2 жыл бұрын

@@mdmtb4807 yes. There are 2 versions (version 1 and version 2) of each Barber for passenger or driver side ring gear. Make sure you pick the correct ones. It doesnt matter if you flip the axle or not, the only thing to look at is what side the ring gear is. Hope you like it!