This flooded my room and I really like it 😍 - Sera Flore 1000 CO2 Reactor Review (Not Sponsored)

Рет қаралды 6,766

5 ай бұрын

Time to retire my little CO2 diffusers and bring out the big guys.. literally 😵‍💫 I just purchased an oversized CO2 reactor and I couldn't be happier! Here, get one too! amzn.to/49E6EDI At this time I see it's unavailable, but maybe it will be in stock soon!
Check out my Amazon Store for inspiration and products I like to use!
go.missorchidgirl.com/shop (For USA)
go.missorchidgirl.com/shopeu (for EU)
Music:
From Epidemic Sound - Get one free month here go.missorchidgirl.com/epidemic
Links towards Amazon, my Amazon Store, Epidemic Music are Affiliate Links! if you buy something through my link you won't pay anything more, but I'll get a small commission, or different benefit. It really helps keep my channel going! Thanks! 😘

Пікірлер: 32

@ArchangelHornet 4 ай бұрын

beautiful tank 😮

@TuanTran-ur8nj 4 ай бұрын

I have 1 orchid but 5 fish tanks. I love that you have this second channel

@dannyaquatics 4 ай бұрын

Great video Danny thank you for sharing.

@ujang0711 4 ай бұрын

Thanks for the thorough review.

@Hydrahandle7 4 ай бұрын

Thank you!

@Agnus78 4 ай бұрын

Hey Danny, thx for your review. I built myself similiar CO2 reactor but using ordinary water filter casing and plastic bioballs. Works well :) As for air bubbles.. this is not only Oase. I've had Aquael Ultra external filter and Tetra EX1200 Plus. They both "produced" air bubbles from time to time. I dont know from where they had it :)

@Nripenbajracharya 4 ай бұрын

Awsum❤

@MrGastonio Ай бұрын

Whats that beautiful fish on 5:15? Great video, thank you!

@Schah375 27 күн бұрын

Electric Blue Golden Ram - Microgeophagus ramirezi

@alastair-r3676 4 ай бұрын

You could be sucking air on the outlet pipe going into the tank where it connects to the plastic pipe. Also when you clean the pre filter and put it back in air is captured which will collect at the top of the filter, what I do is lean the filter over so the pre filter end leaning towards you and propeller is higher for a few seconds, this flushes out trapped air in the filter.

@Danny-MOG 4 ай бұрын

Hi, I’ve actually located the drain sound coming from where the heater is, so it’s probably the threads there or an o ring if it has one, will investigate ☺️

@david94839 4 ай бұрын

The plastic threaded rings should be put on the tubing with threads facing the defuser. Then put the tubing on and tighten the ring back on t the defused. You had the rings on the defuser first, which is why the leaking. ❤

@Danny-MOG 4 ай бұрын

Hi, I’m hoping I understood this right, but those thread rings don’t have a direction, I didn’t even touch them when I reassembled the reactor after it leaked . The problem was either the 2 propellers not sitting right or me not screwing the device straight ☺️

@davidcori2440 3 ай бұрын

I have been using that reactor for 3 months. Today I was going to change my filter floss and the co2 connection on the top snapped off and started spraying water everywhere! It was barely touched. It appears very weak.

@Danny-MOG 3 ай бұрын

Ohh dear 😬 yes I need to clean mine too and it’s making me nervous lol it’s so good but kinda bad at the same time 😂

@Igor-q3f 2 ай бұрын

The filter hoses needs to be as short as possible. With those long hoses the filter looses a lot of flow.

@Danny-MOG 2 ай бұрын

Hi, I don’t have a flow problem, all good here ☺️

@srinivasanberi 12 күн бұрын

Its not available in India 😢

@deShadua 4 ай бұрын

Beautiful tank, scape, community fish, voice, and channel but not necessarily in that order 😎

@wiingus 4 ай бұрын

How do you measure co2 in the tank? I use a sera on a 160L with about 10 bubbles/sec and the drop checker is still dark green

@Danny-MOG 4 ай бұрын

Hi, I use that drop checker you saw in the video. 10 bubbles per second with a reactor sounds like a load of co2 for 160 litres. So what comes to mind: 1. Check if your tested fluid is not expired 2. Check if you have too much water surface movement like an air stone or outlet making too much agitation 3. High temperature? Co2 is less soluble in high temperature, but that’s just theory off the internet not my experience 4. Is your ph very high? I ALWAYS need to use more co2 to get to a certain level when using tap water (ph over 8) than when I use ro or if I have aquasoil. 5. Make sure your reactor isn’t defective.. that’s all I got :)) most importantly though is how your plants grow, don’t stress so much about the colour of the checker :))

@wiingus 4 ай бұрын

@@Danny-MOG ph is 6-7. I think it is the loss to surface agitation. I’m using the aqua rio surface skimmer and lily pipe. Plants and fish are doing well.

@ihsanulusoy16 4 ай бұрын

Me same. I give so much co2 so my reactor can't handle to dissolve it and the drop checker is still dark green. Im planing to switch to the diffuser again because the flow of my filter is also decreased.

@MegaChore123 4 ай бұрын

What size is tubing are you using? Nice tank

@Danny-MOG 4 ай бұрын

Hi, using 22mm tubing :)

@MegaChore123 4 ай бұрын

Thanks you so much @Danny-MOG

@Royjah-sp9rm 2 ай бұрын

So if you don't see the bubbles how do you know Co2 is entering the aquarium?

@Danny-MOG 2 ай бұрын

Hi, by the permanent CO2 test inside the tank and how the plants pearl :)

@jerdrop1632 4 ай бұрын

Sera reactor breaks really easy becuase of al the small plastic hose clamp

@Danny-MOG 4 ай бұрын

Aight I’ll prepare the buckets and towels 😬

@LushSaltyAquariums 4 ай бұрын

Cheers from my fish room channel in Chicago, where I am a delighted to be a subscriber. I love this tank and can see you're quite the aquascaper! But your standards for absolute quiet are perhaps a bit too rigid. In nature, water makes noise. Think of it as "soothing" not irritating :)

@Danny-MOG 4 ай бұрын

Bestie there’s nothing natural about that filter hummm, that’s straight out of Oblivion 😬 as for the water trickling, as I said, I don’t mind it at all ☺️