Thread Tension Assembly HOW TO: Disassemble, Adjust, and Replace Your Thread Tension Assembly

Рет қаралды 35,214

Күн бұрын

Пікірлер: 21

@joebernstein2524 11 ай бұрын

This is one of the best instructional videos that I have ever seen. Everything is explained very well and important points are emphasized and repeated. I can't say enough good things about this video and its presenter. Job well done!!!!!!!

@loribolden6154 6 ай бұрын

Again I Thank you for sharing your knowledge and experience.. Lately I am worshiping your knowledge !

@barbulrey5178 9 ай бұрын

Thank you so much for this video! My entire assembly came out and I was sewing by pushing it back in every few stitches! And all it took was looking for where the Lock Screen was and tightening it!!! I am in business again. Thanks!

@tommyibex2626 4 ай бұрын

just bought and rebuilt a typical gc0303 and this was the final piece of the puzzle getting it all back together. thanks great video

@dfrank2044 Жыл бұрын

Great presentation and well explained from the professional. Thanks

@hirow08 8 ай бұрын

Very detailed. Needed the angle of the take up spring. Thanks for this 👌

@tech-teachSL 4 ай бұрын

Very well-explained. Thank you so much.👍

@maggiemcallister9972 Жыл бұрын

Thank you so much!!!

@jvcovers1003 4 ай бұрын

Bro,thanks Gat that problem fix...🙏👍

@davidsuman2444 Жыл бұрын

Thanks so much 🙏 Sir . Very useful this video 🙏

@ashwadhamini2727 Жыл бұрын

Thanq thanq....

@bulusdavou4865 Жыл бұрын

Thanks a lot

@brianhaddock2020ICU Жыл бұрын

Fantastic.. Top man

@abuhussain26 Жыл бұрын

Thx

@boutch050 Жыл бұрын

Hi Can u do video on how to set the foot max hi for Adler 269

@MahmoudElganzoury 2 жыл бұрын

What is the best sewing machine?

@Ben-uf8eg Жыл бұрын

i cant get the last peice out. the peice that holds the spring

@josephpark2256 Жыл бұрын

Some units have silicone to hold it in or it's just sticky or gunky. Night have to use some needle nose pliers and/or wd-40 to break up the build up.

@Ben-uf8eg Жыл бұрын

@@josephpark2256 used wd40 and two needle nose pliars and still no luck. any other ideas? Thanks for the help

@josephpark2256 Жыл бұрын

@Ben you may have to damage it to get it out (new assembly not expensive so be prepared to get that ordered) There is a little hole where the spring comes out. Use that and put a screw driver against there to hit it (clockwise /counterclockwise) to get it to turn and loosen up. With the wd40 in there already it should break up easier once you're able to get it to turn a little bit. PERSISTENCE/PATIENCE IS KEY! Good luck!

@Ben-uf8eg Жыл бұрын

@@josephpark2256 I heated it up with a blow dryer and got it out!. Thank you