Titanic stuart compound triple part 4

Рет қаралды 1,034

10 күн бұрын

The sole plate is finished and the main bearings are started. When I have help from other channels I will always show them
/ @steamingandy

Пікірлер: 22

@KevinWoodsWorkshop 7 күн бұрын

Keep up the good work Andy.

@modelengineeringadventures 7 күн бұрын

Thanks Kevin

@StuartsShed 7 күн бұрын

Coming along well. I like the DRO graphics on that mill. Nice visualization of the process.

@modelengineeringadventures 7 күн бұрын

Thanks Stuart...if you are looking for a new DRO have a look at Preso's review of his it is quite slick too

@RustyInventions-wz6ir 4 күн бұрын

Very nice work sir. I’m planning to start making engines soon. You set high standards

@modelengineeringadventures 4 күн бұрын

Bless you for saying that.. theres lots of help out there when you need it.

@paulrayner4514 5 күн бұрын

you do like to frighten me don't you, A big drill. a small casting, only 2 clamps with small cockeyed t nuts. I was gritting my teeth, but hats off to you it turned out ok. well done👍

@modelengineeringadventures 4 күн бұрын

I could feel it was cutting well..new drill helps

@MrFactotum 8 күн бұрын

loking good Andy👍👍👍👍 atb Kev

@EnglishHobbyMachinist 8 күн бұрын

Your braver than me Andy 😱 if the drill snatched it would have taken the side of the casting out 😢 but it turned out great 👍

@modelengineeringadventures 8 күн бұрын

As you saw i took it very easy

@Steviegtr52 8 күн бұрын

Coming on nicely Andy. Steve.

@modelengineeringadventures 8 күн бұрын

Thanks steve

@robertwragg9224 8 күн бұрын

You are doing alright dude drilling speed looked a little high for cast iron ,could be the camera . Andy is right for drilling boring bushes it's called line boring guys..

@steamingandy 8 күн бұрын

After you bore the bearings use the faceplate setup to drill the bottom hole for the vacuum pump, it’s easy to forget it, guess how I know.

@modelengineeringadventures 8 күн бұрын

so did I ...its not a problem i love setting the angle plate up hahaha NOT

@steamingandy 8 күн бұрын

Quick tip for setting up, once the faceplate is set use a piece of 9/16” bar in the quill and in the bearing slots to vertically align the casting while you clamp it, then all you need to set is 1/4” from the bottom of the slots, cheating but it works

@modelengineeringadventures 8 күн бұрын

@@steamingandy simple and genius ....its not cheating