Toner Transfer Intaglio
Рет қаралды 18,050
Күн бұрынProduced for Tyrus Clutter's Printmaking II class at the college of Central Florida, this video demonstrates the toner transfer method of intaglio plate production . It also provides development of a copper etching plate using hard and soft ground, and faux aquatint through about eight different states. More demonstrations are available on www.tyrusclutter.com and additional information about the artist's work can be found at tyrusclutter.blogspot.com
@anaphora1 5 жыл бұрын
Excellent demonstration of this technique, thanks for your time in producing this video. The spray paint "false aquatint" is a great idea which I will try.
@The31Souleater 4 жыл бұрын
Simply green household Cleaner was what my colleges printing studio would use to clean off the plates
@trclutter 4 жыл бұрын
The31souleater that is usually part of my cleaning process, but it will not remove toner or spray paint. But it is great for cleaning up after printing.
@154g Жыл бұрын
Are the letters above and below the moon are both raised? If the letters are raised, does it hold ink for a few prints or do you need to re ink before each print?
@trclutter Жыл бұрын
They are more deeply etched, so they do print as an embossment. They were not created to be a dark value (hard ground lines, soft ground texture, or aquatint could be used to darken them if desired), but they tend to hold a bit of ink, especially at the edges. This all depends on how the plate is inked and wiped.
@jessicadonovan6042 2 жыл бұрын
Hey! What kind of acid do you use?
@trclutter 2 жыл бұрын
This was done with ferric Chloride
@kareemnaguib1807 3 жыл бұрын
which printer did you use to print the image to the Transfer paper ?
@trclutter 3 жыл бұрын
Oh, I'm not certain now. It was whatever printer/copier we had at the office back then. Any laser printer that uses toner should work ok.
@kareemnaguib1807 3 жыл бұрын
@@trclutter awesome thanks :)
@154g Жыл бұрын
What does putting it in acid do?
@trclutter Жыл бұрын
That removes copper from the open areas not covered in toner. Those crevices hold the ink that is forced into the paper when it is printed. If all that you did was transfer the image to the plate and didn't place it into the acid then nothing would ever print from the plate.
@154g Жыл бұрын
@@trclutter with the stop out touching up after the transfer, are you just using toner on the brush?
Sok Kimleng
Рет қаралды 18 МЛН