No video
Tongue & Groove Pine Board | TOP THREE Challenges When Installing
Рет қаралды 17,813
Күн бұрын
@gusgusnft8231 Жыл бұрын
What gauge nail did you use? Carpenters in the USA recommend 15 or 16 gauge. Looking at your gun it appears to be 18 gauge or even 23 gauge.
@thehillproject1 Жыл бұрын
Thats good info - thanks for sharing! Our brad nailer is 18 gauge.
@james2shall549 28 күн бұрын
Thank you! installing mine today.
@paulstanescu2759 Жыл бұрын
Hi, te salut din România. Ma bucur sa te cunosc,esti o fata adorabila si foarte priceputa.Te voi urmari cu multa placere.Succes in marele proiect.Paul.
@thehillproject1 Жыл бұрын
salut si multumesc ☺ Very cool to see you are watching from Romania!
@eastbrookhomebrewing2701 Жыл бұрын
Hi thanks for the video. I'm getting ready to do 16' t&g pine on my outside covered deck. A lot of the pieces are decent but have a slight bow to them. Did you have many challenges with that during install?
@thehillproject1 Жыл бұрын
Yes, some boards were bowed and we needed to use leverage to straighten the pieces into place, then quickly secure them using the brad nailer. Occasionally a board was too far gone and needed to be swapped out. Good luck with your project!
@alenaduberealtor9508 Ай бұрын
We’re doing same project on outside covered deck. We’re restraining the boards with Tung oil. It looks natural but some of the boards are curling. Any advice?
@AnitaDevi-so9ls 8 ай бұрын
Nice 🙏
@onemorething100 Жыл бұрын
Can you tell me what gauge Nail you used?
@SkyfalconTin Жыл бұрын
Can I use pin nailer gun for the tongue and groove board to install on ceiling? could the nail be able to hold these board?
@thehillproject1 Жыл бұрын
Good question! A pin nailer with smaller headless nails likely doesn't have the holding power for this tongue and groove pine. I'd recommend a brad nailer or finish nailer for this project
@latishadakin3372 4 ай бұрын
love the project, also how did you do your brick wall, is that panelling?
@thehillproject1 4 ай бұрын
Thank you! Yes, the brick wall is panel. It was really easy to install but we did have some minor bowing due to moisture.
@nicolenemeth9989 7 ай бұрын
Do i not need a gap around the perimeter to account for swelling because of temperature changes?
@thehillproject1 7 ай бұрын
Natural wood products will shrink and swell. Standard recommendation is 1/4" gap around the perimeter. We installed our ceiling in the summer when humidity was highest so opted to reduce the gap anticipating more shrink than swell. Hopefully that works in our favour!
@nicolenemeth9989 7 ай бұрын
@@thehillproject1 thank you!
@paulstanescu2759 10 ай бұрын
Hi Paige,what are you doing how are you
@anthonynguyen6607 10 ай бұрын
Where I buy wood
@thehillproject1 10 ай бұрын
We bought from a local timber store, but you can find this type of tongue and groove pine at Homedepot or Lowe’s too
@laualee1 2 ай бұрын
Yeah I’ll just tell you where I got mine. Facebook marketplace had some Amish untreated tongue and groove pine that the kiln dry
@Redblower Жыл бұрын
that was an easy job...no longer than a day to do.
gregvancom
Рет қаралды 31 М.
The Kelley's Country Life
Рет қаралды 103 М.
Colorado Mountain Living
Рет қаралды 187 М.