Tool Load Management on a Turning Center - Know Your DN, Episode 18

Рет қаралды 404

Күн бұрын

If you have a DN Solutions turning center, tool load management might be at the top of your list of features you want to know more about. Well, you’re in luck! That’s the topic Mark Christopher is covering in the latest episode of Know Your DN.
Got a topic you want Mark to cover? Comment below and we’ll add it to the list.

Пікірлер: 10

@davidlewis624 Күн бұрын

These are fantastic! I appreciate the effort to make these videos. Only a small critique, the music volume is high and makes it a bit difficult to hear the instruction given. For future topics, would it be possible to do a video about setting the Y offset for multi axis lathes? Thanks again guys!

@andrewgrace31 16 күн бұрын

Nice! Could you do a series on Ez guide conversational programming? There doesn't seem to be much available for training on this.

@DNSolutionsAmerica 15 күн бұрын

Thanks for your comment! We will add it to our list of potential topics for upcoming videos. We select our topics based on requests for information. FANUC also has some resources on this topic: kzfaq.info/get/bejne/ns17jaSVzdaXj4k.html

@ReactionTime344 Ай бұрын

here before anyone else

@johnn.katsaoras4958 16 күн бұрын

It is a really nice option that can save tools and workpieces. You could mention also the M200/M201 G code activation possibility also. Is there any chance of modifying values and limits of loss management through G code data input?

@markchristopher5809 15 күн бұрын

John, yes. As I mentioned in the video you can us G700 with a series of variables to define each tool. It is a little complex, so I intend to do a future video in how to cover this.

@markchristopher5809 15 күн бұрын

The example G code would look something like this: G700 M700 T56 Ax, Bx, Cx, Dx, Ex, Fx, Hx, Ix, Jx, Kx, Xx, Qx, Rx, Sx, Ux, Vx, Wx, Zx

@johnn.katsaoras4958 15 күн бұрын

@@markchristopher5809 dear Mark, I really thank you for pointing it out, I was checking the manual but I could not find. Something more on this topic, is there any possibility to activate record mode via g code? Or only monitor mode via M200/M201?

@markchristopher5809 15 күн бұрын

@@johnn.katsaoras4958 Only monitor mode can be controlled via M Code. The record mode has to be done with the buttons only.

@markchristopher5809 10 күн бұрын

@@johnn.katsaoras4958 No. Unfortunately you cannot activate record mode with a G or M code. It requires a human to interact with the control to put it in that mode.