No video
Top End Rebuild 2015 Polaris RMK Assault 800
Рет қаралды 4,723
Күн бұрынFix Kit here
straightlinepe...
Use code EMOND2022 for 15% off
How to rebuild your 800cfi Polaris engine using straightline performance’s durability kit. Did an in chassis video since there wasn’t any real good ones on KZfaq. Leave a comment if you have any questions.
@lukedrakogiannskis8386 Ай бұрын
Great video
@doobyboy21 2 жыл бұрын
Great rebuild buddy ! I just hope you sell your sled before the next rebuild... Red-Loctite is way to aggressive ! Next time you unscrew the bolts the threads will come with the bolts... Been there done that I had to install heli-coils... Anyways good luck !
@tobyemond 2 жыл бұрын
Thanks! I took them off afterwards I forgot to put new gaskets in on a couple spots and they came out pretty easy.
@doobyboy21 2 жыл бұрын
@@tobyemondthe earlier you take them out the easier they are... Loc-tite is like concrete... the older it gets the tuffer it resists ! Never use Loc-Tite on engine bolts just my 2 cents. Use blue next time if you can. I only use Loc-tite on the Y-Pipe..
@chumchisk Жыл бұрын
Hey just wondering. Did you check your ring end gap? Big mistake if they’re out of tolerance. This is a MUST!!! Jus’ Sayin’. Good vid tho.
@Julianne907 2 жыл бұрын
Sicko mode 😎
@nathanduran3663 2 жыл бұрын
Well done. I've got the same sled, 2015 rmk assault with 1300 miles. How many did yours have at this time? and were you loosing compression/performance? Only constructive criticism I've got is to wait crack thermostat bleeder and allow all to bleed naturally. then elevate rear end above bleeder and start sled while cracked then close when no more bubbles are presented. The hose squeeze method acts as a vacuum and gets no where.
@tobyemond 2 жыл бұрын
Mine had 2200 and compression was 120 each cylinder. Ok, that is good to know. I just learned the hose squeeze from my dad. Thank you I will do that next time and if I do another video I’ll make sure to try it!
@kjohns68 Жыл бұрын
You didn’t hone your cylinders?? Why?
@Rickydbaby Жыл бұрын
any preference on orientation of the cylinder base gasket? looks like it can be installed in either direction with the perforated section protruding upward or downward. not sure it matters but getting ready to button mine up.
@tobyemond Жыл бұрын
Pretty sure it goes upward. I don’t think it matters a whole lot but that would make the most sense. Remember to torque the head bolts to half first and then fully once they are half done.
@Emilbrennbakk Жыл бұрын
Where dis you buy the wiseco pistons
@tobyemond Жыл бұрын
Straightline performance
@brockstew2953 2 жыл бұрын
How is it lasting?
@tobyemond 2 жыл бұрын
It’s great so far, great power increase couldn’t be happier with it
@tobyemond 2 жыл бұрын
Another thing I should add is make sure all the coolant is out of the crank when you put the jugs back on. If it’s only a little it should burn off but I would just take it out while you’re in yhere
render.camp
Рет қаралды 571 М.
Making for Motorsport
Рет қаралды 33 М.