Yeah of all the videos you did the best in making remember how easy these carbs are. Haven't done one in almost 30yrs. But watching you simplify the basics like I did them so long ago. I knew how it was running that it was just a couple curtain parts messing up. But wasn't as confident as I was 30yrs ago to dig into it. Even though this would be like my 10th one. Think got older and lost that edge. Not to mention definitely not as many spare parts around compared to my days. When my goal in life was to run these suckers into the ground. Been through 14 of them. And couldn't killm and trust me I tried. But only ones ever made me walk and that was only 2 blocks when chain broke I went from building camaro's when I was 16. To yotas at 18 when I found out was gonna be a daddy and have had atleast 1 ever since. Sadly their almost gone. And this is my last 22r my fave. I've always said these engines are just chevy 350 cut in half. And these carbs are just quadrajunks basic. But thanks great video Peace

You should really make a full rebuild video for the carbs. You have the best video on KZfaq for these carbs

Awesome video. I cleaned up my carb based on your video. Really appreciate it.

this was a huge help, thank you Sir. it gave me the confidence to tear my Carbi off and tear it down and rebuild it. Thanks again !!

Tanks a lot , this vid helped me build the confidence to disassemble my Toyota 12R carburetor , it was a bit dirty but now its all clean and working great. good description and pointer to all the jets and which parts get clogged, that was great. thanks again

wow this video was SUPER helpful!!! MANY THANK YOUS MY MAN!!!!!!!

Man , you are the best, thank you so much for making the effort to do such a fine job . I have 21 R engine , I didn't not find any difference between the the 22 and the 21 Carburetor.

Best 22r carb vid, thanks!

got it. thanks again supper helpful video for my carb rebuild!

Thanks for putting this video out. So helpfull

I am really impress your video..thnks

Thanks man you helped me out a lot did you ever make a video on the choke??

I rebuilt the carb the engine sputters what do you think it could be? Thank you for this video it was really helpful btw.

Great video, thanks, just one question, I have an 86 extra cab truck with 22R engine. the chock does not keep the rpm high , when cold. it runs very rough and ideals slow and very bad. it spits out carbon until it warms up and then sits for a while. then it runs fine. it runs fine at high speed but does not ideal properly. Any ideas how to fix the chock ? I replace spark plugs and wires but did not help.

What is the electrical solenoid right above the accelerator pump it has three screws holding it in. The other one is the fuel off right that screws in.

Nice work

Will the float bowl vent or the fuel shut off solenoid cause it to not have fuel at the accelerator pump and or not idle. I have to spray

Is there trick to installing the o-ring For the fuel cutoff solenoid? I know you stated hit it with some oil but my o-ring keeps sliding off/back as i start to insert it. Will it seat itself if i try to position the o-ring in the hole?

Thank You bro

great video. also liked the one on disassembly. I am rebuilding a carb exactly like this. I put it back together but the flapper at the top next to the choke stays closed. im not sure what opens it. the arm that comes up from the bottom doesn't go up enough to drive it open. I also replaced the diaphragm for the choke but I wasn't quite sure how to position all the springs behind the choke thermostat. im not sure if I needed to rotate the thermostat when putting it back together to give it some spring tension. any comments would be appreciated. thanks

And if you don't like opening up a little can of worms or box of worms... You can buy a new TOYO 505 round plug carb for less than 100 bucks shipped on eBay or Amazon.... They also have the grey square plug version.

This video was super helpful! Are you going to be doing a choke assembly video?

Mi pregunta es en donde lleva las ligas y unas postas que vienen en la caja de los repuestos

How do I know when I need to rebuild my carburetor? MY 84 Toyota 4x4 starts and runs just fine but I was told that it could use a rebuild. (Im not very intelligent when it comes to vehicle maintenance, just basics)

I may have found the pesky Asian carb float bowl draining over nite problem....I removed carb, filled float bowl through the vent hose to proper level and worked both accel pumps...the next morning I found fuel leaking out the vacuum hook up for the auxiliary accel pump. Seems there is a pin hole or defect in my new pump diaphragm....Ive been chasing this problem for years and hope Ive found it....at least the fuel is not going down the manifold but is getting in the vacuum line and sucked into the motor. If it still drains I will have to go back to filling the float bowl through the vent line every morning to avoid long cranking when cold.....

At .37 you mention checking the power valve is not "sticky? ". You mention (but do not show) a spring associated with the power valve piston you removed, in the top of the carb. Is there another spring that goes in the carb bowl (where you removed power valve) that can become "sticky" ?

With no vacuum (engine off) power piston is pushing power valve open. With open valve, what keeps fuel from leaking out of reservoir?

My 1985 22R Toyota, with engine off, float reservoir leaks fuel into intake manifold. I replaced POWER VALVE and installed full carb kit. It still leaks, but much slower. I see the power piston is pushing power valve open when I install top carb plate. Should power piston be pushing power valve open during install / engine off?

My 1981 22r has a problem with those two valves they don’t close just open but don’t close witch causes the truck to choke and turn off not sure if it chokes or just runs out of gas don’t really know but if I keep giving it gas it’ll stay on and when it’s been driven for half hour it’ll stay on until you turn off and turn back on it’ll do the same .. how can I fix those valves

Great video...I hope you can help me out. I have an '82 Toyota Corona that has sat for a long time (months on end). I replaced the fuel pump and it worked fine for the last several months. Last week, however, I drove it one day and when I returned to use it again after a couple days, it idles fine, but dies when you step on the pedal. It starts back up, but will die again on acceleration. I could only go about 25 mph because if I pressed anymore, it would die out. I cleaned the bowl, lower throttle plates, replaced the three diaphragms in the kit, etc. to no avail. Any idea?

what about soaking in a cleaner? is that nec?

How much you charge to rebuild carb 1987 truck green plug

My fuel bowl goes empty while at idle but the filter stays full. The bowl refills after the engine stalls in-tank electric pump is new denso. The fuel cut off solenoid seems to be working also. I just did a rebuild and thats the current issue. Thank you for any advice.

I have this same Carburetor and after it sits overnight the gas leaks out of the bowl and down into the engine. Any suggestions about what may fix it or should I replace it?

Mine sat for a while now it will not idle or start without spraying carb cleaner down the carb like the primer has quit working. It really didn't sit that long maybe 3 months. I have drained the tank and put in fresh fuel with sea foam still not working right. It is on a 83 model 22r. Pulling my hair out looking for vacuum leaks for the idle problem but the loss of prime is ????

Where does the opening below the power valve go to?(0:15-0:33) I tried blowing it out with air nozzle but no flow. I tried pine sol dip, gumout carb aerosol can, air, and using guitar string to clean it out.

Hola!! Necesitó saber porque mi toyota hilux año 88 no queda andando en baja

hello sir! does this model carb have accelerator pump check valves? My accelerator pump is barely squirting gas out and I would thing it's a clogged valve

Esto me interesa lastima q esta en ingles

ok

I have a 85 , and mine won't start without being primed with gas. It runs alright after that until I get on the highway (sometimes) then it acts like it's not getting any fuel. Spit/Sputter until I let it rest. I changed the fuel filter, and I took it out and it seemed to run fine. Then I left my house, and it sputtered for a few seconds then it ran fine. My float bowl was below the middle today. Would Seafoam help fix any problems, or should I return it? Thanks for any help!!!

Can u please do a choke assembly video asap??

If this guy would talk louder and have the camera on what he is explaining it would be better