I'm trying to replace break power booster. But from driver seat, very hard to get to those 4 bolts. How do I remove the plastic cover panel under the steering wheel? I found 2 screw on left and right bottom and removed those. And used a flat screw drive try to ply open the plastic cover from top. But doesn't work. I can not find any youtube about this problem.

Very good friend thank you very much I made the change myself at home..👍

You didn’t adjust the the pushrod inside the booster to leave a 1/16 inch gap between the master cylinder piston when seated. This is important so the brakes don’t drag or take to long to activate

Pkai pnya kijang bso dak om

Disculpa que Toyota es al que le están cambiando el booster

Sir, order ko booste pump toyota corola model 1995

Bs that u removed that so easy lol I’m catching hell trying not to fuck up the lines

Sir, order sana ako booster pump toyota corola model 1995

parehas lang ba hydrovac ng 2e at bigbody gli 4afe?

gud day po. paano poba malaman kung sira yung brake bosster po. 2e din po sa akin. sa akin kc pagdiinan ko yung brake pedal nagiiba po yung idle vibrate napo makina. unti2x lulubog pedal pero kumakapit pa naman yung brake. lalo napo pag gabi on lights at naka ac pa pag diinan ko yung brake pedal bagsak po yung idle po. sana po masagot nyo. salamat.

Sir sa opening video po san po 4 nuts na tinatanggal mo? san banda?

Sir. Ung sakin kapag kapapaandar sa umaga, palyado xa tapos pag uminit na ok na. Then tumatakbo at pepreno pumapalya tapos mamamatay ung engine.

Need pa po ba ibleed pag binalik brake master? o salpak lang din po?

boss, magkano score mo dyn, at saan mo na score.

Magkaiba ba bigbody at smallbody hydrovac

Sir magkano po bili nyu sa hydrovac corolla 2e

Sir, order ko booste pump toyota corola model 1995