Toyota 4Runner: How to Fit 33 Inch Tires with Aggressive Offset Wheels on a 5th Gen 4Runner

Рет қаралды 46,589

Жыл бұрын

Toyota 4Runner TRD Off Road Mod List:
Suspension:
Eibach Pro Truck Lift
JBA Upper Control Arms
Treaty Oak KDSS Spacer
Energy Suspension Bump Stops
Cornfed 1/2" Rear Coil Spacer
Wheels/Tires:
Yokohama Geolander G003 M/T: 295/70R17
Factory TRD Wheels
Spidertrax 1.25" Wheels Spacers
Lighting:
Assortment of KC's and Diode Dynamics

Пікірлер: 73

@josephbrunson7672 5 ай бұрын

Best look I’ve seen yet, love the stock wheel setups!

@airsoftdude36 10 ай бұрын

How to fit 33s on a 3rd gen: just put them on.

@monkeyman5 8 ай бұрын

You can put 35s on 2nd gen

@LulzFam-th2yb 5 ай бұрын

You can put 40s on a hilux

@user-fi1xu1pp7p Ай бұрын

You can put 100s on an FJ40 😂

@Enea_28 10 ай бұрын

Good looking car with good sounding music,perfect

@InGratitudeIam 3 ай бұрын

No BMC needed if the lift is at 2" or less and you keep the offset at 0 or +4. Going wide will, in addition to the mods you mentioned, increase the stress on the wheel bearings and steering rack. You might consider installing ARK mudflaps as they are much thinner and will help protect your paint. The tint on your front window might attract unwanted attention from law enforcement.

@davintang4672 3 ай бұрын

I'm in California, so no worries about law enforcement since they don't actually enforce laws here. I could literally drive without plates if I wanted to.

@Jayyy-7 2 ай бұрын

lift doesn't increase tire clearance

@DJGERSONOJEDA Ай бұрын

@@davintang4672Hola David quiera saber si esa medida de caucho en la mía con 3 pulgadas de elevación puede servirme sin que pegue en ningún lado y gracias

@Scottstunts Ай бұрын

Correct on all points

@sevendewey Ай бұрын

I have no body mount chop and 33’s fit fine. But I’m also on the stock TRD pro wheels

@Vanburglar Жыл бұрын

Looks good.

@heyitschinoable Жыл бұрын

Can u show the front bumper cut u did? 4R looks amazing

@sugargold4126 5 ай бұрын

Beauty!

@icecream_2987 9 ай бұрын

How much does something like this cost?

@Bru946 6 ай бұрын

Arabella is a classic

@mion1981 23 күн бұрын

Will those tires fit on the TRD Pro wheels?

@The_unknown656 Жыл бұрын

Love the set up , how they feel on road? Are they too loud ?

@davintang4672 Жыл бұрын

They're audible and noticeable, but I wouldn't say loud.

@genxsis953 Жыл бұрын

Wouldnt the spacers push the wheel out and cause more rubbing with the higher negative offset?

@davintang4672 Жыл бұрын

Yeah, but in my case they were necessary. The 295's with the stock wheels would rub on the JBA control arms without the wheel spacer.

@IMUHBOXER Жыл бұрын

Where did you get the mods done?

@tuckerhiggins4336 10 ай бұрын

The spacers and negstive offset actually decrease your clearance. Learn how ifs works

@Record3677 9 ай бұрын

You hit the upper control arm with wider than a 275 i thought

@tuckerhiggins4336 9 ай бұрын

@@Record3677 That means you don't need them

@Record3677 9 ай бұрын

@@tuckerhiggins4336 yeah i should’ve been more clear- on stock wheels you’ll hit the uca with anything wider than a 275. To fit 285 i needed 0 offset wheels. When i tried spidertrax and stock wheels the steering felt crappy

@richardcarter4649 7 ай бұрын

@@Record3677yeah but you rub on the body Mount and fender liner. Aftermarket UC arms will prevent rubbing on control arms

@mulligatawni651 5 ай бұрын

@@Record3677 False. 285/70-17 on the stock wheel will work just fine without spacers. Ran 285s for years on stock wheels and no spacers. 285s work on stock suspension and lifted. Just had to trim the front bumper and adjust the front of the wheel well forward.

@rebeltake 7 ай бұрын

You want 0 offset for max clearance I can only fit 305/70/17 with -12 offset

@randomuser6306 Жыл бұрын

No rub at full compression and full turn? Serious question, as I live in Dubai and driving on sand means all travel on suspension is used all the time

@davintang4672 Жыл бұрын

At absolute full flex with wheels turned it rubs a tad on the inner fender liner. I could cut more but it's pretty minimal so it doesn't bother me.

@user-vs7gz4pg8v 5 ай бұрын

did he not lift it?

@chillonmedia1 7 ай бұрын

what lift is this ? looking at getting 295s in a few days

@davintang4672 7 ай бұрын

Eibach Pro Truck Stage 1

@camaroboi13 3 ай бұрын

Imagine having to cut up your car just to put 33s on it…

@alauen Жыл бұрын

Do they fit in the spare tire rack?

@davintang4672 Жыл бұрын

No, I tried, but it was rubbing, so just left the stock spare for now. Going to get a rear bumper with a tire carrier in the future.

@a04a27 10 ай бұрын

eibach Pro-Truck Stage 2R Coilover Kit Front Coilovers + Rear Reservoir Shocks + Pro Lift w/2-4" lift, i went with this one. stock rims, going for 285/70/17s. guys, do you think this will rub? without any trimming? i just wanna take sa mud flaps

@xxtm72xx63 10 ай бұрын

You'll probably need some adjustable UCAs and a wheel spacer if you're trying to get away from the body mount chop

@a04a27 10 ай бұрын

@@xxtm72xx63 i will do that. thank you!

@xxtm72xx63 10 ай бұрын

@@a04a27 no problem, 0mm - 18mm is the offset you need to do without the bmc just for a heads up!

@a04a27 10 ай бұрын

@@xxtm72xx63, thank you so much!!!! planning on getting the Black Rhino Raid 17x8.5 -18. bless you! been eyeing that for 4 months

@edilbi 6 ай бұрын

How low you can go with psi?

@davintang4672 5 ай бұрын

I've never gone below 15 psi. You could probably go lower if you wanted to.

@zenofthemoment Жыл бұрын

You didn’t mention lift. It’s definitely lifted. What did you do there?

@davintang4672 Жыл бұрын

It's on an Eibach Stage 1 kit. Didn't mention it in the video because technically cutting matters more than lift when it comes to fitting large tires on these IFS vehicles.

@Jayyy-7 Жыл бұрын

IFS lift does not increase tire clearance k should be able to clear 33’s with no lift

@4nathanscomcastnet Жыл бұрын

How much of extension was extended on the front bump stops ?

@punxnotdead3873 9 ай бұрын

I did twice that with my stock orp this weekend in co. These are built tuff. Dont need more than 31s imo.

@punxnotdead3873 9 ай бұрын

@davintang4672 how do u like the eiback, was thinking abou the stage 2 . 2-1 level. No uca needed

@danerg69420 10 ай бұрын

lol my 4th gen runner fits 33s without rubbing stock, but fit even better with my long travel kit😈

@CMJSC1997 Жыл бұрын

how much lift

@davintang4672 Жыл бұрын

Front: 2.75" Rear: 1.5"

@angelcorona8331 Жыл бұрын

Any regear to be done?

@davintang4672 Жыл бұрын

I wouldn't say it's absolutely necessary. Borderline though.

@zachpeat5076 11 ай бұрын

I’m running 305’s with no regear

@juanwick2726 10 ай бұрын

33's came stock on my JL

@moisesolmos175 6 ай бұрын

Tire size please

@davintang4672 5 ай бұрын

295/70R17

@moisesolmos175 5 ай бұрын

thank you. Did you update the suspension or is it the original?

@ericbrianestrella4479 Жыл бұрын

do you need to regear?

@davintang4672 11 ай бұрын

I'd say it's borderline there. It might bother some people but to me it's fine for now.

@ernestorobles3029 11 ай бұрын

Did you weld the body mount chop or just chopped it ?

@davintang4672 11 ай бұрын

Chop and weld new plate.

@Shmity1962 2 ай бұрын

You must of failed geometry in school, there’s no need to cut anything

@saltybuttskin Ай бұрын

Maybe if you’re just driving around a parking lot. 285’s rubbed for me I’m sure 295 will need some trimming

@ynestroza95 8 ай бұрын

Gay as song

@XploreAz 24 күн бұрын

As what song?