Toyota Corolla cv joint change VVTi clicking sound

Рет қаралды 3,538

Жыл бұрын

Please show your support by clicking "LIKE" and "SUBSCRIBE" to come along for the ride!
Want to support the channel by buying me a coffee? www.buymeacoff...
Visit my Amazon shop, it's free!
www.amazon.com...
www.amazon.co....
----------------------------------------------------------------------
Filmed with the excellent Sony ZV1
DE: amzn.to/31bBym3
US: amzn.to/3hdn3E1
CA: amzn.to/3bExXB2
UK: amzn.to/3aEh4Wg
SWE: amzn.to/3oMr9be
IT: amzn.to/3I2VHhC
ES: amzn.to/3pe9Kbp
---------------------------------------------------------------------------------
DJI Osmo Action 4: click.dji.com/...
B-roll camera, DJI Osmo Action 3
DJI: click.dji.com/...
US: amzn.to/3ConA36
UK: amzn.to/3e0ZHoB
DE: amzn.to/3e1OIey
ES:amzn.to/3dVeJwc
---------------------------------------------------
DJI Mini 3 Pro: click.dji.com/...
DJI Pocket 2: click.dji.com/...
-----------------------------------------------------------------------------------------------------------
If you would like to help support Italjohn's channel, please consider making a donation. Any money raised will be used to buy tools and equipment to help produce new videos. Click this PayPal link to make a donation: www.paypal.me/...
www.buymeacoff...
------------------------------------------------------------------
www.italjohn.com
www.tubebuddy....
/ italjohn
/ italjohn
linktr.ee/Ital...
/ norwayvanagon

Пікірлер: 3

@danielw8302 2 ай бұрын

Thanks so much! I am in the middle of this right now - You need a 32mm 12 point deep socket to remove the orginal hub nut. I didn't have one so I cut the end of the shaft off with an angle grinder and used the shallow one I had. When grinding the out the bits that retain the ball bearings I ground through most of the way then gave it a sharp whack with a hammer and it just snapped the rest off. Only needed to remove about 4 balls and that was enough to release the rest. I am now stuck removing the circlip so have left for the morning. Will also need a 32mm hexagonal deep socket for replacement cv joint. Thanks again.

@ainstaink8312 9 ай бұрын

Is clocking important with these kind of Joints? VW (2006 or newer models) use the same style outer joint and the inner joint is like the one on the Porsche . Do balls on the inner and outer joints have to be aligned (In line)?

@Italjohn 9 ай бұрын

That's a very good question. I have not seen anyone done that on modern cars. The joints are different on the inside compare to the Porshe (or Vanagons) I would clock the Porsche ones, but not sure it's absolutely necessarily, as the suspension travel is very short compare to a "off roading" car like the Vanagon syncro