Thank you for the feedback

@@eazidiyhello i have a question i did all of it but i cant find a proper antenna adapter that fits my 2002 toyota highlander

Unfortunately I do not have a link as I did not use an antenna adapter in the video. Please check online.

What is the name of the friend cable that I want to buy from JBL.

did your hybrid come with the touchscreen system for the a/c? and how does it work when replacing it with this kit?

You are welcome!

Awesome, good to hear that. Have fun!

Welcome on board bro! Thank you for the sub.

Sure

Self tapped to the plastic trim. I created an indetentation first with a drill bit and drove the screws in afterwards.

It must be connected to the positive (red wire) of the reverse light. You may use another wire to extend to it.

How about the black ground wire where did you connect it to ? Please

There is a ground wire in the trunk. White with black strip wire.

The car was off, I only turn the engine on for testing.

The air vents get popped out of the office frame and they are placed into the new one. You may need to use plastic panel removal tool

@@eazidiy I can remove the vents from the original frame but they do not fit the new frame.

@@RunTheRockers I have one like too in one of the job I did. Remove the grills of the air vent. I should work.

Please check on Amazon for antenna adapter

I do not understand your question. Can you elaborate more?

@@eazidiy what happens is that in my toyota highlander there is a cable that is next to the antenna cable that is not connected to the screen and because of that it makes a strange noise

No. That noise is cause by ground loop

The video I made is for 2001-2006 Highlander. 2007 is 2nd Gen. The wiring is different.

** Metra 70-8113 JBL Harness amzn.to/3VW4GaP ** Axxess AX-MLOC740, 745, 780 amzn.to/3BzblQd ** Universal 16-pin Android Radio Harness for Toyota amzn.to/3hgSwdS

Here is a link to another video I made on how to connect JBL highlander kzfaq.info/get/bejne/idt-g9Zh36ixp3k.html

I ordered this one, would this work?

It will work just like it in the video I made on it. Follow my wiring diagram and you won't regret it.

Ok thank you for the reply

I have the link to buy the radio in the description box of the video. Aliexpress.com or ebay

My battery was connected all through the installation. I did not disconnect it.

Thank you for your answer :)

@@clobear22 You are welcome

Hi, the canbus didn't work for the JBL highlander. But I later used line-output converter amzn.to/3HNb2Ud. I have another video on how I installed it kzfaq.info/get/bejne/idt-g9Zh36ixp3k.html

That is strange. The orange wire on your harness is typically for dimmer. When headlight come up, your radio should dim but not turned off. You could snip the orange wire and see if it resolves the issue

Do you have an Android radio?

Is the new radio an Android headunit or just a single din radio?

@@eazidiy it is just a single din radio

Ok. You will need to buy Metra 70-8113 harness amzn.to/3MxoU8R

Note: connect both pin 10 ( black/white) and pin 20 ( black wire) of the Metra harness to the ground of your radio harness.

Note: Connect pin 3 ( blue/white) Amp on wire of the Metra harness to the Amp on wire of your radio harness if it has one. If not connect it to the red wire +12v Acc of your radio.

I have links to buy in the description box of the video

The line output converter or Metra harness?

What year is your highlander? For the adapter, do you mean jbl harness or line output converter?

@eazidiy found what I needed I didn't realize having the jbl system in there made a difference ty tho

You are welcome

Lol! Not that bad.

Philadelphia, PA

Easy job I'm sure you can do it

** Android Radio: Aliexpress.com tell the seller that you are from EAZIDIY for discounts $2.00 discount for orders over US $98.00 use code: K384LC6SMXZQ $5.00 discount for orders over US $188.00 use code: L702LQ733L2B $8.00 discount for orders over US $258.00 use code: 1TCM5GLLCPXU Use this link from Aliexpress www.aliexpress.us/item/3256804167436734.html?spm=a2g0o.productlist.0.0.12cc6908b7aTTD&algo_pvid=9e69d0f3-1e6f-4e98-96cb-76d9557b805c&algo_exp_id=9e69d0f3-1e6f-4e98-96cb-76d9557b805c-0&pdp_ext_f=%7B%22sku_id%22%3A%2212000028889558561%22%7D&pdp_npi=2%40dis%21USD%21187.94%2193.97%21%21%21%21%21%402103399116710307569547725e690f%2112000028889558561%21sea&curPageLogUid=IkeSWChpWjXt

Yes, I have something similar on my online shop eazidiy.square.site/product/car-stereo-subwoofer-4-channel-line-output-audio-converter-with-power-amplifier-control-wire-plastic-black/1?cp=true&sa=true&sbp=false&q=false Make sure to use Metra 70-8113 harness for your connection Harness amzn.to/3VW4GaP

and everytime i roll down my window theres like a lil static click at the end

I have this video on my channel to solve the static noise kzfaq.info/get/bejne/idt-g9Zh36ixp3k.html

Check my video kzfaq.info/get/bejne/idt-g9Zh36ixp3k.html

Yes, JBL canbus didn't work. I had to rewired the harness with line output converter. See this video kzfaq.info/get/bejne/idt-g9Zh36ixp3k.html

Follow me on Instagram @eaziteks

@@eazidiymessaged

@@eazidiylet me know when you got it

I got it. Thanks

The canbus harness came with the radio. But that didn't work for Highlander. You will need a Line Output converter and make connections with Metra 70-8113 harness. Check my video description for details