Replaced my second generation rear lift gate back door locking actuator. It was stuck closed and trying to open.
Пікірлер: 12
@pwells479
Yep thanks, yours is the first video I found on a 2nd gen.
@olypop36
The battery diconnect part saved my marriage. Thanks for that....i think
@jeffj3077
Thanks for the vid! I went with the knockoff actuator from eBay for around $80.00. Fits like a glove and works fine so far. I did have to disconnect the ground wire from the battery for a minute or two after install and then bam it worked!
@jontaylor3134 Жыл бұрын
Worked like a charm
@user-qv6ej8di8y
Thank you very much!!! Where did you buy your part ? Toyota?
@user-qv6ej8di8y
I have the motor out. Still can’t get the mechanical part out. Any suggestions. Pulled on two levers .
@Mm2m4nsur
Thanks for the video. I replaced actuator on my Sequoia but when i closed the door it wouldn’t open. My question is how to make actuator work properly?
@jamieedwards5372
Thanks - mine is stuck too. I managed to get all the panels off, and even disassembled the motor just like you did. But i still cant figure out how to get it open. Once you had the plastic off etc - how did you actually make it open?
@harryjason5485
I bought new lock for my Sequoia because I thought that the it is the reason for lifting gate problem , which is not working automatically. Unfortunately, i lost my money without benefit from buying this new lock.