I wouldn't have the nerve to do that trans shaft swap, but you gave me some hope 😊

Nice work. Transmission looks very intimidating. I bet it feels good to have it done.

Wow,! I give you credit, there is no way in hell I would have attempted that. I would have pulled out the credit card. Good job.

Awesome video, turned out nice!

lol shift forks messed me up too! Not because i couldnt get them all together, but because i drove the roll pin out for the alignment collar [so i can install the rod while the forks are installed] and i ended up putting the collar on upside down....... couldn't figure it out for 3 days...... had to remove a sealed bellhousing 4 times before i caught it..... talk about frustration, but now i know and like you said, these things will be a breeze to go through now. :D

Great channel ! I wish I could build my trans am like this .

I’m currently putting together a 67 Camaro it’s got the gen v lt4 with the ten speed automatic 12bolt posi body was chemical dipped all original panels no rust California car

Incredible job.

Wow! That just blew my mind. Great job.

Schaeffler \ Luk is really good quality! They OE to every vehicle manufacture.

Man thats nutz. Good for you. Just do it! Id have to have a GOOD manual to even think about attempting that build. Ive got a 6sp Hellcat with the 6060. Id like to faceplate it but i would have to send it in for sure

You don’t happen to have part numbers for the clutch and flywheel by chance?

Dude that was amazing much respect

Best part 26:15 😂… Shows you have the same struggles and frustration as the rest of us sometimes

Is there anything you can't do?? Amazing!

I have to ask Chris, what's with the use of the word "we?" Do you have an invisible assistant? 😉 You pretty much seem to be a one-man army to me. A tour de force if you will.

Sweet video man! Is it ideal to use that bearing grease vice just lubricating the bearings with the transmission fluid you'll be running? Also, I love those press tools you used towards the end pressing those gears on.

Great video. Takes guts to tear the guts out of that transmission. Will that clutch and flywheel setup fit my 2005 CTS-V LS6?

love this series !! had to subscribe, what was that book you had on floor at 7:03 ????

Do you have any info on where the tr6060 came from? I sourced one from a 2014 hellcat and need to adapt it to my gen3 6.0 h.o. Looks like the bell housing isnt integrated into the rest of the case

Where did you get the parts to do the t56 conversion? I scored a free tr6060 and want to do the same thing for my cobra.

How much power are you putting through this clutch and how is the feel. I can looking at this clutch set up at rockauto

That was so fucking cool

Any way you could list the individual parts for the conversion? I'm looking to piece a kit together...IT WOULD BE VERY MUCH APPRECIATED!!! THANK YOU

Hey Chris, we just picked up a LS3 but has auto trans. We are wanting a manual. I noticed in the video the 6060 to T56 rear. The question i have is did you do this to avoid the cost of just getting a T56 trans? I'm wondering if we should just buy a T56?

Rockauto's price for my flywheel is $1000

Have you had any issues with that bit of wear on your input shaft from a pilot bearing? I did this exact same mod to a tr6060, only to realize after assembly that the input shaft was worn down too far from a pilot bearing in a past life. So i get to tear it down again lol

Where did you get the kit to do it? I have a tr6060 now.

What did that setup cost all parts included

Where did get the the conversion kit

Who did you have tune the holley terminator x for you?