This video shows how to repair Trailblazer / Envoy wipers that bounce, jump, chatter, or stop while on intermittent mode. The repair is simple and takes less than 1 hour.
Пікірлер: 62
@daviddias34737 ай бұрын
Wow. This is the video that nearly escaped me. Just as I too was about to spend $200-$300, I searched KZfaq one last time. Thank goodness. I and my 2002 Trailblazer thank you so very much!!
@onestepclosertoday2 жыл бұрын
Just wanted to thank you for posting this video. I have a 2002 Envoy that had that exact same problem. The control module is no longer available individually to purchase for my vehicle. The mechanic wanted to charge me $300.00 for putting on new wiper motor which includes the module. I went in this morning and took the module out and cleaned it myself as you suggested instead and it works perfectly. You just saved me $300.00 plus the cost of the new part ($166.00) plus tax. Thank you for sharing. Roger
@FishingandRacing2 жыл бұрын
You are very welcome. And FYI, mine is still working perfectly.
@ag32115 жыл бұрын
Just got to witness my wife's wipers work on all speeds for the first time after following your video. Thanks a lot OP.
@markspehar76384 жыл бұрын
Hi, Ran across your video and thought...hmmm! Did this process on my 02 TB w/144k. Works great!! Thank you for your time to instruct us!
@chadvondran28872 жыл бұрын
I FINALLY got around to doing this today on my '02 Bravada (5 years later! (Identical setup as a Trailblazer, no Antenna on Bravada's though, lol) Absolutely nice and smooth wiper operation now, I also fixed a clogged washer nozzle since i was all up in it! 😀 Thanks for the perfect video!! Incase anyone else has a clogged nozzle all i did was soak the nozzle in vinegar for a while, then sprayed through it with an air compressor! Boom, like new again!
@ernestpaul24845 жыл бұрын
I know that this a 4 year old video, but it saved me some money and downtime on my wife's 02' TrailBlazer. Once apart and on my folding work table, (did the work in the driveway under the pines) all I did was remove the gear cover from the motor assembly, wiped the excess grease that had spilled over from the worm gear with a paper towel. The contacts were cleaned off using some Mass Air Sensor spray on a paper towel and wiped off. Reassembled to the point of the wiper arms (painted a matte black and let dry overnight in the house) and this morning put them on, checked the operation throughout the entire range, removed the painter's tape from the windshield and that was it. Thank you for posting this fix.
@LSmiata2 жыл бұрын
Hello FishingandRacing, NICE video and thank you for post. I used it to replace my washer nozzles that are under the cowling. Had a broken one that was squirting strait up! Cheers! Mr .P
@mikeburton17035 жыл бұрын
SON YOU ARE A LIFE SAVER.....I WAS ACTUALLY GOING TO GET A NEW WIPER MOTOR FRIDAY.......IF I WERE CLOSE TO YOU I WOULD GIVE YOU A KISS.!!!! THEY WORK GREAT......SUCH A SIMPLE FIX BUT I AND MANY OTHER HAD NO IDEA WHAT WAS THE PROBLEM.....THANKS ALOT.....
@jerryhooker25736 жыл бұрын
Thank you for the video. Have been pricing new motors when I ran accross your video. After watching, I just tried it on my Trailblazer, and it worked great.
@jameswhite50835 жыл бұрын
Was quite easy to do, wipers work great now. Just be careful with the plastic on the motor, work it slow by the plug with a screwdriver and you will be fine. The terminal tool I bought was made in China, after fighting with it I got the first wiper off but it wrecked the puller. So the passenger side one i used a screwdriver to pry against the metal plate under the plastic shroud on the wiper end.. be gentle and work it around a little bit and it will pop right off.. easy peasy
@RamanMikhael Жыл бұрын
Thank you. This was exactly my Envoy 2002 issue as well. Nice and smooth wipers now.
@TEBCO1235 жыл бұрын
How did grease get there in the first place ?
@samsuleiman65436 жыл бұрын
Thank u brother for this video I did exactly what you said and it worked I saved 200 dollars thanks brother
@workaholic50410 жыл бұрын
What did you clean the inside of the motor with?
@dadholly31337 жыл бұрын
Thanks for the wiper problem. I cleaned up the extra off of the white gear and contacts and took care of the problem.
@chadleisenring8419 Жыл бұрын
I tried the battery post removal idea...no worky...I ended up grabbing it with a pair of pliers and rocking it back and forth and it came off REALLY easy.
@bookreader90810 жыл бұрын
I did this today trying to fix my wipers that have completely failed. Sadly it did not fix the issue. I can hear one tick when I turn them on but they do not move at all. Thanks for posting this. At least I know what to do when I get the new motor.
@GLEby-wz5pn6 жыл бұрын
Kim Su did you figure out what the problem was?
@mr.whiskaz82105 жыл бұрын
i also hear the ticking but no movement
@johns48705 жыл бұрын
My wipers just failed completely. I think a motor assembly replacement is going to happen after i check fuses and relays. Thanks for posting the video so i know how to take it out and the terminal tool .
@rmthunder5 жыл бұрын
Thank you for the video! It helped me get the wiper motor replaced in under 2 hrs!
@DTechnologyservices8 жыл бұрын
this worked perfectly for me! OK I used throttle body cleaner for the silver metal side and electric cleaner for the motherboard side.
@DTechnologyservices8 жыл бұрын
also I used wd40 on the metal just a very little so it can rub smoothly, it's also good for super hot or super cold temperature
@joriver695 жыл бұрын
Thanks for posting this. It worked great for my Pontiac Sunfire.
@michelletimmons52275 жыл бұрын
Thank you for posting!
@jessdemerath9 жыл бұрын
Great vid. I was having the same issue and this fixed it. You just saved me a little money.
@luisguerrero29145 жыл бұрын
Excuse me, mines only work at the highest intensity level. What can I use yo clean them? Also, Do you think cleaning them will be the solution?
@berrymcgregor40987 жыл бұрын
outstanding I was hesitant but a perfect fit, before I started project I disconnected the washer connection at passenger fender (top) after reinstall booth sprayers shoot over the windshield, it is in the exact spot and tight fit , there are no spray adjustable nozzles, I would understand one side but both, it's almost as too much pressure but the chatter and jerking problem is repaired, any thoughts on my new problem? thanks again Obie Juan kanobi
@altec2277 жыл бұрын
Thankyou very much for the video, i was able to fix it without a problem, this helped alot!
@DominikSteck8 жыл бұрын
thanks for posting this
@nascarusa19 жыл бұрын
Works great! Thanks for the helpful video.
@MegaErick20078 жыл бұрын
I'm gonna try this great video! I hope it'll fix it, mine works only on high.
@tonyirby85606 жыл бұрын
MegaErick2007 did it work for you? Cause mine only works on high as well
@_1ben5 жыл бұрын
Tony Irby tony what did you do, as mine only works on high as well?
@_1ben5 жыл бұрын
Great video I posted a. Comment 3 years ago ,,, update the grease is there for a reason, I cleaned with brake cleaner though all, in sprayed white lithium grea and dryer, se, so the grease is a problem and a fix
@jsauerii5 жыл бұрын
My first thought, the grease is there for a valid reason, remove it and new problem incoming soon when you wear it all down because the grease was gone.
@rafaelbeltranjr44384 жыл бұрын
@@jsauerii ..i agree, it is supposed to have Dielectric grease, or similar...
@GordyHammerle7 жыл бұрын
Thanks for the video! I've had this same annoying problem for a few years. Now I can fix it! Did you use any type of adhesive/RTV on the housing when reassembling?
@FishingandRacing7 жыл бұрын
I did not apply additional RTV. There was so much factory sealant left, and still soft / pliable, I did not think it was required. However, it would not hurt it you do so. I hope the fix works for you.
@willdog34 жыл бұрын
I took my 06 TB wiper out and the wiper assembly looked exactly like yours, but the electrical internals look completely different. The wheel has no contact to the board like yours, and the board is shaped differently and has like 100 tiny resistors and capacitors on it. When I look up the part it looks exactly like mine, can’t even find any like yours. Wish there was a known way to fix my style, cuz cleaning it did nothing and a replacement board is over 100 dollars. Smh
@chadvondran28878 жыл бұрын
Ok awesome i need to do this.. I've been dealing with this exact problem for over 3 years on my '02 Bravada.. BUT isn't there a reason for some grease to be in there? Or where would it have came from?
@FishingandRacing8 жыл бұрын
+Chad Constant There will be plenty of grease left after you clean the contact areas. I suspect the grease softens and spreads onto areas it should not be after years of use and exposure to hot under hood temps. Mine are still working perfectly today.
@chadvondran28878 жыл бұрын
FishingandRacing ok awesome, makes sense. I gotta do this soon! Great video also! Thanks!!
@berrymcgregor40987 жыл бұрын
FishingandRacing have a situation maybe your thoughts would be helpful. br_mc@yahoo.com thanks Berry ,btw outstanding clip
@JohnnyFlips5 жыл бұрын
Thank you!
@octavioruiz647 жыл бұрын
good video thanks
@yaneznayu99978 жыл бұрын
Sweet, thanks!
@WesternGuilfordLacrosse5 жыл бұрын
What year is your trailblazer? I have a 2004 and my wipers will cut on and not stop. I have to pull the fuse.
@jsauerii5 жыл бұрын
ACDelco 19120931
@ag32115 жыл бұрын
Do you recommend using Electronic Cleaner for the inside of the motor?
@rafaelbeltranjr44384 жыл бұрын
..i would say, contact cleaner is best to use...
@juarezlevi8 жыл бұрын
good...
@54coupekid7 жыл бұрын
Good video on how to get the assembly out, but you are wrong about the grease. That is supposed to be in there.its contact grease. Very similar to what's on a horn ring.
@FishingandRacing7 жыл бұрын
Removing the grease instantly fixed my problem as detailed in the video. They work flawlessly 3 years later. Maybe just a coincidence? Who knows. I am happy, and so are many others. Thanks for the compliment though.
@54coupekid7 жыл бұрын
FishingandRacing I've said many times I'd rather be lucky, than good. Cheers
@luisguerrero29145 жыл бұрын
Excuse me, mines only work at te highest intensity level. What can I use to clean it? Also, Do you think cleaning it will be the solution?
@hellcatredeye-g65826 жыл бұрын
Cording to my daughter as a little different of a problem
@JasonSpitzMI504 жыл бұрын
I bet you never had that problem in a Toyota but only in general motor cars 😒
@MTM-1709 жыл бұрын
wipers inop.
@sandyhipkins9523 жыл бұрын
Why do all these videos say they will show you how to replace your back windshield wiper but none of them do there all the wiper arm it's super annoying and why don't they do a very good job of showing you that i don't understand why does he say u don't need to see what he's doing sounds so stupid wale up men show in detail and go over it a few times us women weren't taught this stuff so some of us this may even be thier first time working on a vehicle so why not go over stuff or at least do a good job of showing exactly what to do.