Nice love my nitro I ran a stinger pipe on my slayer just put up the video
@RedsWay-hz6np7 ай бұрын
O yea what's your KZfaq I want to check it out
@terryshrives83226 ай бұрын
Get yourself a 11k carb made by os. It will save mass frustration.
@RedsWay-hz6np6 ай бұрын
Your the 2nd one to say that Traxxas one's must be junk? Is that what you run
@brettmiller35646 ай бұрын
@@RedsWay-hz6np traxxas carbs are junk. Get a losi 3.4 carb or os11k will wake that 3.3 up
@terryshrives83226 ай бұрын
@@RedsWay-hz6np yes it's what I run. And yes the traxxas carbs are junk
@RickyD19683 ай бұрын
Your Jato is smoking fast !!! Daaamm Jina !!!! lol
@RedsWay-hz6np3 ай бұрын
Lol thanks and that's Clyde 🤣🤣
@jakeandrules77244 ай бұрын
My rc10gt single speed with a modified .21 and really tall gearing for top speed on foam tires like i mentioned is close to 100mph. I use a buku adjustable clutch and buku pipe with a servo dedicated to control the divergent cone (end cone) for good low end power popping wheelies with good mid and excellent top end power. Pretty slick, they used that same technique in go karts called a "slippy pipe". I can control the position of the slippy pipe from my transmitter. I was breaking axle shafts left and right till i modified my all steel gear/ aluminum case transmission to accept the jato axle shafts, all is good. The aluminum trans case added some much needed weight for traction also.
@RedsWay-hz6np4 ай бұрын
Sounds like a bad ass rx car I want to be in the 100 club
@rcsendandblast15797 ай бұрын
Holy man I just have to drool at the sound of the happy singing nitro engine.
@RedsWay-hz6np7 ай бұрын
Lol it's beautiful isn't it I'm loving it also. I want to switch pipes to the tuned pipes the chrome ones
@rcsendandblast15797 ай бұрын
@@RedsWay-hz6np I just bought a cheap Amazon aluminum pipe so I could try it out to. I can’t afford a expensive pipe at the moment. Man your tune was so close at the end of the vid. Not sure what your gap is at right now but your close. A hour or two richer in the low needle and that might help drop the idle Yes it does run great 👊😎once you balance those needles it will come natural after that. It just takes a bit to learn to keep the high speed rich as rich gets so the low can stay nice and hot for torque It takes a bit but your almost there. Just richen the low speed very slowly and get the idle lowered with the gap at .7 mm exactly 👊😎
@RedsWay-hz6np7 ай бұрын
Yo what did u pay for that one? The JATO ones are only 50 bucks how's it working out for you though. They add horsepower and there tuned pipes I'm definitely putting them on mine when income tax hits lol
@RedsWay-hz6np7 ай бұрын
I'm going supercharger on my new one since it has the speed thing on it go to rp innovations they got everything for nitro
@rcsendandblast15797 ай бұрын
@@RedsWay-hz6np it’s in order I just ordered the pipe to see. I hope it sounds good. I’m sure it will 👊😎 I will post a bud of it when I get the car finished. I just replaced the backplate for better engine seal. Don’t forget air can suck in the backplate to. A little hint a guy told me to check every so often on a traxxas motor. 👊😎
@Tegridy_Rc7 ай бұрын
Good ol jato
@RedsWay-hz6np7 ай бұрын
😁
@michaelgraham29437 ай бұрын
Nice driving that jato is fast
@RedsWay-hz6np7 ай бұрын
Thanks bro gotta have skills to handle one of these took along time of practice lol she fast stock so far untill I upgraded gears
@JeremyTurner-wv9id7 ай бұрын
That jato is fast
@RedsWay-hz6np7 ай бұрын
Yea she is gonna mod it to go in the 70s next summer hopefully. I gotta get the app working so I can get that top speed
@Jato-Junkies7 ай бұрын
Check out the jato video I posted....
@kevinkev15307 ай бұрын
👍🏾
@terryshrives83226 ай бұрын
The glow starter on these is notorious for instantly burning up glow plugs
@RedsWay-hz6np6 ай бұрын
Ok how do I avoid that use my plug igniter instead
@terryshrives83226 ай бұрын
@@RedsWay-hz6np Yes
@RedsWay-hz6np6 ай бұрын
K
@user-en2md9ck8u2 ай бұрын
My nitro fusion will run out of site on that jato dude
@RedsWay-hz6np2 ай бұрын
😂😂😂😂
@rcsendandblast15797 ай бұрын
Low needle is lean. Turn it counter clockwise 230 degrees hard ripping is a good temp.
@RedsWay-hz6np7 ай бұрын
Ok bro probably gonna get it out today I'll be sure to do that 👍🏾
@rcsendandblast15797 ай бұрын
@@RedsWay-hz6np I was just out on the porch and the sky is showing some blue patches up there. Might turn into rain Though. I sure hope not. If not I’m going out for a test with my freshly fixed up Nitro Rustler The only thing I’m not satisfied with is the new shafts I just got. I got the old school tough MIP CVD axles. They shudder like crazy. Wtheck lol. Anyway it hasn’t blown a shaft since the swap. It just shudders as soon as the cars picked up off the ground. The CVD’s don’t like to be angled they only like to spin steady when the axles are bone straight. Lol. Oh well it’s still tough. And has some small bugs to work out. Thank goodness the engine is all done and ready for round 10. Ohhh I have another great tip for you. They’re a little expensive but we’ll worth it in the long run. OS LC3 plugs. They’re really well built and the coating on the wire last much much longer than any other brand of plug out there. I got my first 2 0S LC3 plugs this week to test. I’ve heard so much tuning benefits also so I had to try them. My first test will be today hopefully 👊😎
@RedsWay-hz6np7 ай бұрын
Will that fit in the trx 3.3 engine??? I'm not sure what I'm gonna do I'm at work right now might run the JATO again no rain here just cold
@RedsWay-hz6np7 ай бұрын
O and I need sum good tires maybe slicks or something that doesn't swell I hate the anaconda
@rcsendandblast15797 ай бұрын
@@RedsWay-hz6np The OS LC3 long reach plug indeed is the best plug for the 3.3 and the 2.5 traxxas motor. 👊😎
@cipherviper40935 ай бұрын
I took out the ez start and glow plug wire in my jato, revo and slayer pro and gone with the pull start and ignitor so much better cause with the wires constantly being pulled out and re installed with new plugs those wires get easily ruined making it difficult to start the car plus in my 3 trx 3.3 engines I took out that crappy traxxas car and put in the os 11k best upgrades done to my cars, look into it yourself man you wont regret the upgrade.
@RedsWay-hz6np5 ай бұрын
Yo! SO I can relate to that Ive replaced wires on both JATOS numerous times yea they suck had pull start but it got screwed up but not saying I don't like them just don't have any right now lol and as far as that Os 11 Ive looked into them $$$$$$ I'm gonna need to figure it out but I'm trying to turn them into drag cars over winter just don't no we're to start and what I should do to beat lipo cars....
@maxbenard50227 ай бұрын
Do you have the speed telemetry sensor?
@RedsWay-hz6np7 ай бұрын
Yea all that is on it I bought the truck brand new and it use to work I need to try it again maybe something was turned off
@markmccullough68734 ай бұрын
don't forget to after run manitance
@RedsWay-hz6np4 ай бұрын
Okay 👍🏾
@jakeandrules77244 ай бұрын
Every time you take it out before starting, back your high and low needles out at least a 1/4 turn and adjust in from there. Cold temps need more fuel to start and stay running. Also, make sure your fuel tank is sealing well. You already know about the carb being crappy and for that matter, any air leak into the fuel system or engine will cause it to run like crap or erratic. Every damn piece that comes apart is suspect
@RedsWay-hz6np4 ай бұрын
Ok bro Been thinking of I had sum air leaks or not could be possible can't find a good carb to get been hearing about os but they expensive lol starting to warm up here spring soon better temps I hate tuning in the cold
@markmccullough68734 ай бұрын
jato 3.3,slash 3.3 .slayer pro 3.3 ,rustler 2.5R
@user-gp1sx7mr3e5 ай бұрын
More smoke the better
@RedsWay-hz6np5 ай бұрын
💨💨💨💨 always if not then prepare to blow your engine I guess I have overheated one and wasn't good
@cody1995evo2 ай бұрын
She was lean mr that why she’s spitting at wot
@RedsWay-hz6np2 ай бұрын
Yea then was rich at same time hs was broke and didn't no it
@keithmathers67192 ай бұрын
I have jato tranning are junk went thus 3 of the then put all metal gears in tranning
@RedsWay-hz6np2 ай бұрын
Only went through one messed with shift screw and went bad
@favulus12 ай бұрын
better get some better plugs. look up cold weather tuning man. the colder the richer. the warmer the leaner its not idling well at all. the idle is entirely to high.. you are killing a good engine
@RedsWay-hz6np2 ай бұрын
Okay will do but I'm familiar with that just something was off with carb
@RedsWay-hz6np2 ай бұрын
Just posted video showing what the reason was
@markmccullough68734 ай бұрын
whats up red jato sounding good. im in ohio to northcental ohio;it can be a bitch in the cold i have learned to warm them up before i cut it lose.the oil in the fuel needs time.hope this helps.
@RedsWay-hz6np4 ай бұрын
Ok sounds like I'm supposed to do that cause I've heard that like 20 times 😭😭 guess I should keep the blow dryer in handy
@jakeandrules77244 ай бұрын
Get foam tires for front and rear for on road. Grips better especially if you use the liquid brush on traction promoter.
@jakeandrules77244 ай бұрын
Straight foam tires are awesome and dont grow with speed like the stock rubber tires