This is an easy, semi-permanent solution to the driveshafts falling apart on the TRX-4M due to the o-rings not being able to hold the pins in. It is cotton thread wrapped in the slot and glued in place.
Пікірлер: 14
@80SWoods Жыл бұрын
Nice. You should trademark this as the “fly tying” method of driveshaft repair.
@johntimbes6510 Жыл бұрын
"Now, this here is my pin-capture knot..."
@jimbo42038 ай бұрын
Just one drip of silicone caulk on each o-ring and wa- la problem solved
@johntimbes65108 ай бұрын
That's a good solution, too.
@Jonn1969 Жыл бұрын
Shrink tubing is easier!!!
@johntimbes6510 Жыл бұрын
Sure it is. This is just a way to fix it if you don't have any or don't want to take the driveshafts off.
@Elisplushies360woodierc Жыл бұрын
How about just fill that gap with shoo goo or some type of caulking
@johntimbes6510 Жыл бұрын
That might work, as well! Even easier than my method, just let it dry overnight.
@Elisplushies360woodierc Жыл бұрын
@@johntimbes6510 👍🏼👍🏼
@scaleaddicted Жыл бұрын
Put a shrink tube over, done.
@jasongilbert6992 Жыл бұрын
I haven’t had any problems with mine (knock on wood😂) when is this happening? I play with mine only inside
@johntimbes6510 Жыл бұрын
I've only read about it on forums and on Facebook. Some people have theirs come off the very first drive. I suspect it's whenever anything contacts the driveshafts, like crawling on big rocks. I decided to do this fix so I don't have to worry about it.
@ironj100 Жыл бұрын
(I put white PTFE THREAD SEAL TAPE OVER THE DRIVE SHAFT AND RUBBER RING. )SO WHAT CAUSES THEM TO FALL OUT. IM JUST GOING TO USE MY TRX 4M for trailing with a little crawling at times. Also I Have Thread lock glue would that work.
@johntimbes65108 ай бұрын
I think they get caught on things or dry out and crack.