Yes, it will work fine, probably better than on my scrambler cause there's more room on the rack to mount it. The rad is the same size as mine. The new High lifter kit is nice to, its a little less angle if you want a lower profile but I believe its more money.

Kaleb Wagner they should be the same kaleb, the only difference between the 850 and 1000 is the bore size, the physical size of the engine and frame is the same on both sizes.

You are right, they come up beside the handlebar pod, I did mine more to get rid of the lines to make room for the cvt and air intake line that come through the same area.

I hooked mine up to the baffles that came with the kit but yes, they run up under the speedo so its just extra insurance, I like the baffles just in case it was to flip over in the water.

michael rhodes it was 1.5” line, I ended up having trouble with blowing belts as it should be a 2” line imo I would either change the intake, exhaust to 2” or add a blower to the line if I was to do another one.

It held up fine but I did burn a belt or two before I sold it.

Dawid Drewniak it's 2" for the engine and 1.5" on the cvt, the cvt is not big enough, ended up blowing belts from overheating, go with at least 2"

3666scott How much does it cost snorkel kit in your country? I'm from Poland and I looking chip snorkel kit. You can write on my email addressee: szyja123@interia.eu Or you can find me on Facebook Thank you

Dawid Drewniak I think the kit was around $200, it was a couple years ago, got it off eBay, it was a nice kit but I did have an issue with blowing belts after, the cvt is to restricted with 1.5" pipes, they need to be 2" like the engine snorkel.

3666scott thank you for help 😁 I try find snorkel kit on ebay 😜