Triumph Bonneville T140 - Front Wheel Bearing Replacement

No video

Triumph Bonneville T140 - Front Wheel Bearing Replacement

Рет қаралды 1,565

Bodganeering

11 ай бұрын

The 46 year old front wheel bearings were a bit crunchy...

Пікірлер: 12

@droidster888 9 ай бұрын

Reminds me of why we bought shielded bearings for our skateboards when we were young… nicely done mate, lots of great info on your channel. I have a 76 T140. Thanks for your efforts!

@bodganeering 9 ай бұрын

If only there was some sort of nipple where we could force grease into it to lube the bearings… 🧐😂 Thanks.

@droidster888 9 ай бұрын

@@bodganeering there’s a thought! Probably won’t have to do that again for quite a while though!

@colinstares6207 2 ай бұрын

Good informative video, nice to see you have those invisible voids where you can’t see things right in front of you 👍 What size socket did you use for the smaller bearing drift? And did you refit all the bearing dust covers with the new sealed bearings?

@bodganeering 2 ай бұрын

I can't remember what size socket I used to drive the bearings in with, a pretty big one. But you can also use a brass drift as I did on the second one. As for the dust covers, I fitted them on one side as they helped space out the bearing in its housing, I know some people don't bother with them. I'd say that's your call.

@rickconstant6106 11 ай бұрын

I'm lucky that I haven't had to do this to my 78 T140V yet. After 60000 miles the wheel bearings are all still good, but mine has never had anyone else interfere with it. One thing I might have done differently is put a couple of the disc bolts back in to clamp the two halves of the hub together, otherwise you are relying on the spoke tension to hold them in place while you knock the bearings out.

@bodganeering 11 ай бұрын

Good call on the bolts. This bike has only done around 25,000 and it looks like the bearings have never been looked at, doing the rears next so let’s see what surprises are there… 😂

@AaaaandAction 9 ай бұрын

12:04 could you not use outer part of the old bearing race with saw cut across it to drive the new one home? Saw cut allows you to get old race out again.

@bodganeering 9 ай бұрын

You could but a good bearing fit would make it difficult to get out.

@AaaaandAction 9 ай бұрын

@@bodganeering ……. Which is why you put a cut across the race. Done it many times on many bearings, last month on an Ifor Williams wheel bearing.