Fantastic video! Easy to follow step by step for first timers. Especially the vacuum lines and release freon steps. Thank you for sharing 🙏

Best video on how to set this up by far! Great work!

Good video…love the views of both sides. Easiest video to understand from all I’ve watched. From what I know you aren’t supposed to crank down really tight on the flare fitting because you will crack them. This is true for the vacuum pump too because there is a plastic o ring that gets hyper compressed and ruined if tightened too much. Also the coils need to be coiled horizontally as to not allow a build up of oil in the loops. Great vid

Awesome video. I talked to Maegan on phone and she walked me through on setting the remote control and converting the Celsius to Fahrenheit in a couple of easy steps she was very professional and I would advice anyone to call their supply house for any questions. Highly Recommendations. Thanks Maegan!

awesome i just went and check your store going to order two from you soon

It would be nice if you would do a video on the proper settings on your remote for best economic use and saving on electric bill. Justin enjoyed your video. Now do one on the remote settings. 😊😍😎

Excellent video. Thanks. Only one question, for clarification.... did you start the unit BEFORE you released the refrigerant? Wouldn't that build up an awful amount of head pressure in it, or is this a more-sophisticated compressor than the old 1990s dinosaurs using R22 that I've monkeyed with in the past?

Great video!👍

Is there a way to run the electrical all outside with a disconnect box? Or do you have to have a wire falling down from the inside unit and use an outlet? Thanks.

Great Video! I am considering installing one of these in an RV. I was trying to see on the video, is it possible to run the lines and drain tube out the side of the head unit instead of the back as long as the drain tube is at an downward angle? I would like to run the lines inside the coach and out through the floor to the compressor which would be mounted on a stand in front of the trailer. The lines would run under the trailer and thus not seen until they come up to the compressor.

Hello, this video was made July 2022 we’ve learned a lot since then, pulling a vacuum like this is not a true leak test! We do require our customers follow this step to clear the indoor unit and lines of any air, moisture, potential contaminants that can affect the outdoor unit. You can always reach out if you have additional questions 480-338-6197 Dustin 573-410-2769 Megan MINI SPLIT SUPPLY ROLLA MISSOURI

This was amazing

Do you have any videos on the comfortotal 220v installation?

thank you

I have the same unit that came with the house I bought.. but my question is does this unit generate heat on winter time ??

Thinking about purchasing two of these and wondering what outside temp will it work down to in winter weather and still heat inside? Thanks

Could you tell me how to move the vent from left to right. I can make it go up and down.

So this unit gets power from a plug indoors instead of outdoors? Is that the case for the NG too?

I tried to call Dustin at the number provided, not sure what region you’re in but I live in Missouri just needed to clarify a question on a 220v system. The units that have the plug that come out of the air handler (same as yours in the video but 220v), is this plug where it gets all of the high voltage main power from?

Just curious why would you fire unit up before releasing the Freon wouldn’t think that would be good on compressor to pump with service valves closed.

Nice video, How can I contact you? Do you ship?

Do you have a unit that I can plug into the inside outlet that has a longer line set? I would like to do a second floor installation.

Do you know how many seers is this unit?

I washed a mini split coil where the homeowner had run the equipment when a renovation had takennplace. What a nightmare.

Well this sucks. My unit has the flexible drain tube on the opposite side of the lineset. Is that a manufacturing defect? Leaking on the inside like a sunova. Not sure how to even try to fix this now that everything is hooked up. Are there possible two outlets on the drain pan and I can open this up and move the drain hose over to the other side where everything else runs out directly?

Is this unit powered inside through the header (wall plug)? Sorry, looking for an option where I have a full circuit breaker already.

The entire system, head unit and compressor is powered by the inside 120 V wire?

Where's the fuse located?

I have a confortotal that won’t cool was freezing and another one that blows cool but not cold. Been trying to get the contractor that installed them to come out for months. Would you say it’s probably Freon leak

Is there a template for locating the hole positions.

One thing I missed or it wasn't shown in your video your head unit had a power cord attached? Did you attach that, or did it come with that? Now I am confused, I just bought an Everwell mini split (very similar to the one in your video) and the electrical cover on the condenser has two holes in for power/signal cables, so I was assuming that I had to have an electrician to hook me up some outside power for the condenser unit. It is a 110v system, the handbook that came with it is worthless, that is why I have been watching so many you tube videos. Can someone help with this? Thanks.

Does anyone have that brackets (inside one) dimensions or an install template?

This is an invalid training video. It doesn't show pressure test prior to vacuum. Sustaining vacuum does not guarantee a tiny leak is not present.

I have a question... I installed one in my house and I followed all the steps in the manual and the video as well and my compressor only turned on for a few minutes and the fan only turned on when I put it in fan mode. Do you know why is that happening

This 110V confortotal systems is designed to be wired to a quick disconnect outside by the compressor, right? I noticed you used a plug-in cord that looked like it was connected to the head unit. I don't want that I just need to make sure that is not how this system works before I buy it.