Tube Puller

No video

Tube Puller

Рет қаралды 93,183

Winema Agencies

Күн бұрын

Tube Tracktor

Пікірлер: 18

@babyanthony8359 Жыл бұрын

I had been in this field around 15years.assembling new bundles,re tubing old heat exchangers,boilers etc...horizondal,vertical,and U bundles.

@entertainmentbyraza5667 3 ай бұрын

Can I contact you by email sir ?

@angelvillarruel1374 Жыл бұрын

Excelente. Diga que operación esta realizando con el equipo en el Haz de Tubo.

@Nad7334 6 жыл бұрын

How do you disconnect the tube joints at both ends

@amjadnajjar3511 2 жыл бұрын

hi what is the brands of the tube puller I need same

@dharmeshgor539 2 жыл бұрын

Is it possible to pull welded tubes??

@jaygendre8325 5 жыл бұрын

locket Rotor alarm kyu hota hai Sir ji

@meocats 10 жыл бұрын

how are the tube re-inserted?

@metalwiddler 10 жыл бұрын

I would think you can just slide them back in and then recrimp the ends on each side on the new ones after but I could be wrong lol

@meocats 10 жыл бұрын

it looks like a press fit, and if you were to crimp it would leak? At that length, even if crimping, sounds like a huge problem to align them

@metalwiddler 10 жыл бұрын

After dragging the whole length of that tube out corroded up I doubt that hole would stay "tight" long I believe up here there is a "flaring" type tool to seal the ends up, they could also be welded in, sounds like grinding or cutting the welds on the back side may be what's happening with the background noise there. To get them in you'd have to start with the bottom ones to support the ones above them inside and just feed them in, you would have someone on the other end with a stabber to help guide them through the other tube sheet. Not my specialty though I do more of the machine work part of it not the tubes themselves.

@chazzlebazzle69 6 ай бұрын

Called tube rolling