No video
SEADOO DESS POST REPLACEMENT: Speedster 150 project Part: 2
Рет қаралды 2,890
Күн бұрын#seadoo #jetboat #seadoospeedster
We pick up an old Seadoo Speedster Jet boat and start to clean it up and fix it up! The DESS key post we have suspected to have failed so we are replacing it in this episode.
HERE IS THE LINK TO THE DESS POST
amzn.to/450sNta
HERE IS THE LINK TO THE WIRE STRIPPERS
amzn.to/3qf6hxT
CHECK OUT OUR GREAT SELECTION OF PARTS AND MERCHANDISE!
www.lowboostfi...
GET YOUR LOW BOOST MERCH HERE!
www.amazon.com...
VISIT THE LOW BOOST FILMS STORE
www.amazon.com...
CLICK HERE TO SEE ALL OF MY OTHER VIDEOS
/ turboclipse182
CLICK HERE TO SEE THE 1953 FORD F100 BUILD
• 1953 F100 RESTORATION
My Equipment
Gimbal-Ziyhun Crane 2
amzn.to/2HgHrY1
Camera- Canon Rebel7ti
amzn.to/2Kp3Cwr
72 inch Tripod
amzn.to/35MM5Xo
Mic- Rode Video Mic Go
amzn.to/3lNfJkC
3 Suction Cup Mount
amzn.to/35KXfvJ
Music- FREAK THAT, by Fayzed - • Hard Trap, Guitar Chil...
@DdF-uz3tc 4 ай бұрын
Hi I'm new to the channel will you be doing more on the 1996 jet boat their is alot of people into those boats and KZfaq lacks people fixing them so it's nice to see you are working on one.
@LowBoostFilms 4 ай бұрын
Yeah, as the weather gets a little nicer, we are going to keep working on it
@shawn_yates Жыл бұрын
I love solder connectors, but I made the mistake of using them in an engine compartment and the heat in there degraded the solder over time and it took me forever to figure out that was the reason my engine kept dying. Good crimp connectors are best in hot environments. Looks like a fun project!
@LowBoostFilms Жыл бұрын
I was thinking that too, but these are not in the engine compartment, so I think I should be OK. But you are right nothing beats a good crimp.
@MisterBewst 4 ай бұрын
Are the engines rotary or piston?
@LowBoostFilms 4 ай бұрын
Piston
@angelon7095 Жыл бұрын
It's likely those engine are full of oil. If these engines have never been rebuilt the crank seal will be leaking.
@LowBoostFilms Жыл бұрын
Ugh, fingers crossed
@frankpoleck3742 6 ай бұрын
It’s so common with these. Mine leaks I just installed ball valve inline to keep the oil from dumping in when not in use
@FriendsOfTheRoad 6 ай бұрын
Did you get it to run?
@LowBoostFilms 6 ай бұрын
I got it to turn over a little but I think the starters are bad. Gonna replace them next
@user-kq7te9cx7x 6 ай бұрын
And how fast can this boat go in the water
@LowBoostFilms 6 ай бұрын
Like 45-50
JET ARMOR, INC.
Рет қаралды 18 М.
Papa Don Jet Ski
Рет қаралды 29 М.
Kevin Eleven Outdoor Adventures
Рет қаралды 8 М.