@danielnixon1976 4 жыл бұрын
A tip to remove grips on the bars, without damage. Use a air nozzle through the hole at the end of the grip, and have someone on the other end of handle bar block the other hole. Stick in the nozzle and blast with air as you pull off. Same thing on the other side. Just block off the end of handle bar. Place the nozzle in the grip. a blast of air. They will be off in seconds. Instead of cutting off a good pair of grips.
@4wd35 6 жыл бұрын
These things are awesome!!!! Very easy install
@michaelmatchee 8 жыл бұрын
spraying the inside of new grips with hair spray helps. it helps lube to slide and when the hair spray dries it gets sticky holding the new grips in place.
@rmatvmc 8 жыл бұрын
+michael bigchief Awesome. Thanks for the tip!
@travisswartz3992 5 жыл бұрын
michael bigchief bbjjjnj
@cnaef19 4 жыл бұрын
I have always installed grips this way.
@rkproductions1061 7 жыл бұрын
why do my grips he up when the four-wheeler is on but the switch for the grips is off? please help. thank you
@stephenchapman6472 6 жыл бұрын
for some reason when I connect the accessories wire and turn the key on it blows the fuse, any ideas ? I have a 5amp fuse that keeps blowing.
@dlansburg2673 7 ай бұрын
0:11
@frank-sy8xu 8 жыл бұрын
whats the meagneto
@Onenasty306 8 жыл бұрын
+frank bastone Magneto charging systems make use of permanent magnets imbedded into the flywheel assembly. The assembly is located on the “mag” end of the crankshaft.These magnets are passed next to coils of wire assembled into a “stator”. Alternatingcurrent is generated in the coils. This is converted into DC power.
SWANKY CAT
Рет қаралды 9 М.
NORDEN AMERICA - Husqvarna Norden 901
Рет қаралды 9 М.