Tutorial #3 | Advanced Operation with RM-IP500 Controller | Cinema Line FR7 | Sony

No video

Tutorial #3 | Advanced Operation with RM-IP500 Controller | Cinema Line FR7 | Sony | α

Рет қаралды 19,811

Sony | Camera Channel

Күн бұрын

Пікірлер: 20

@greggibson7485 Жыл бұрын

PLEASE PLEASE PLEASE re-do this video to include the fact that VISCA OVER IP is OFF by default on the camera. You have to set dip switch 3 to ON on the back of the camera. This is a HUGE OMISSION!!! The dip switch setting is not mentioned in either the documentation for the RM-IP500 itself NOR the FR7 documentation for using the controller. It is buried in the section specific to the dip switches themselves in the FR7 manual. Why would anyone assume a dip switch change is required to use the controller? I spent more than 5 hours trying to solve this problem.

@ApiYanMachan Жыл бұрын

Thank you so much. You save my life 😉 I also spend more than 5 hours to connect it.

@EricWeberGoogle Жыл бұрын

Yes thanks !!! Just got off the line with pro support for this very issue !

@ampman9 10 ай бұрын

You have saved me sooo much headache for this comment 🤝

@Carlito-Fxwg 2 ай бұрын

Thank you so much...at work they install new equipment and no info on how to do anything on it..

@TheJadedFilmMaker 2 жыл бұрын

I want!! I want 2 and just sit down now when filming weddings

@myoti9831 4 ай бұрын

This RM-IP500 work with SRG-X40UH? I'm tired of trying to configurate them; camera register with mac address synced, however zoom and pan tilt does not work.

@sydneysmit Жыл бұрын

How is the multiview at 3:03 achieved? Anyone knows?

@CarlAustinGregory Жыл бұрын

an explanation of that would be helpful for sure.

@Tigerodoes 6 ай бұрын

One great setup for a dedicated robo op is to have NDI studio monitors open for each camera's feed. Have the camera native info display on with waveform/af point etc. along with tally info on studio monitor settings and you have superb ergonomics for the op!

@Livestream-events 10 ай бұрын

Does the controller have PoE

@ApiYanMachan Жыл бұрын

Hi, I just got FR7 but I'm struggling it connect to IP500. It's says camera connected but I can't control it. When I checked camera table I can see FR7 ip is there. Do I need to update IP500 firmware?

@payneguin01 Жыл бұрын

Make sure the 3rd Jumper Switch from the Left on the FR7 is in the up position

@payneguin01 Жыл бұрын

Also make sure you are on Version 2.2 firmware

@payneguin01 Жыл бұрын

Just Seen Greg Beat me to it by a month! Just wasted 2 hours before I found the link