Go back and adjust miter, maybe not perfect 45°. Use glue and blue masking tape. Pull the points together instead of rolling open edges making pockets.
@user-yy9wb2gp9c8 ай бұрын
木目がピッタリですね でも年輪のところでちょっとボコりそうですね、けずるより綺麗かな😮
@lambrettali-19597 ай бұрын
ピン角で納めたいときは?
@user-oq6np1yw1p8 ай бұрын
歪みが気にならないところで使いたいです。 あと、湿気とかで戻ったりしませんか?
@twcdesign8 ай бұрын
できればノリ入れます!
@holohulolo8 ай бұрын
Im assuming those are real wood veneer? Usually when you make the veneer bigger in size than the surface and then send down the edge as you slightly fold them down, the joint will be seemless. But maybe because of the precise geai matching you cut them to exact size?
@woodskip8 ай бұрын
That is not veneer, look at the block more closely. It is a solid block of some kind of pine.
@CountDoucheula8 ай бұрын
Solid pine. This process is called burnishing
@Saint_Bezdelnik7 ай бұрын
Отвертка именно wera только или любая подойдет? 🙂
@A_i__8 ай бұрын
Wera製加工棒(ドライバー)
@user-su5mz6pf6x8 ай бұрын
じゃぁVESSELじゃダメかぁ😦
@user-nn8we7zv1s7 ай бұрын
マイナスドライバーしか持ってねえ
@twcdesign7 ай бұрын
プラスマイナス関係ない😂
@user-hh9uq2vj1u8 ай бұрын
Надо взять, на заметку.
@woodskip8 ай бұрын
That might work if no finish is applied. The finish would likely pop the wood back to its original shape.