Good job, you took your time, lighting and viewing the video were perfect, and from watching your video - I discovered that my floor is uneven and the toilet moves( I go for a ride every morning).
@fixitjohnАй бұрын
Awesome, thank you!
@peterhernandez37909 ай бұрын
Thanks for the info.
@fixitjohn9 ай бұрын
Any time! I’m glad that it helped. Thanks for watching.
@nathanclaycomb25113 ай бұрын
Good video! Gonna tackle my parents today...
@fixitjohn3 ай бұрын
Good luck!
@tripjet99919 күн бұрын
Wax ring should first be mounted onto the bottom of the toilet, not placed on the flange.
@fixitjohn19 күн бұрын
@@tripjet999 Yes, it works both ways. I have done it both ways. Thanks for sharing.
@etmeyutubАй бұрын
How do you screw a screw into a concrete floor? Is it a certain type of screw? Do you need to drill a hole first?
@fixitjohnАй бұрын
I use just an average wall anchor and tap it in after I drill it out. They sell those at the hardware store as kits with screws in the kit. I hate to tapcons.
@stanb99027 күн бұрын
The flange is flat Why not just turn it over at use the correct orientation
@fixitjohn27 күн бұрын
Hi Stan, Thanks for watching. If you look closely on the corner of the flange you will see that all four corners bend down and out where I put the screw's through.
@stanb99027 күн бұрын
@@fixitjohn okay On.mine the flange is flat I was actually heading out to install it in a 100 yrsr old house when I commented. Ended up that it didn't matter Everything was so far out of square spec and whack I had to improvise. Ended up using one Phillips tapcon, one sheet metal screw and two deck screws of different sizes. But it looks good from my house
@fixitjohn26 күн бұрын
@@stanb990 good job. I hope you got paid well for it.
@tripjet99919 күн бұрын
@@fixitjohn The screw's...what?
@suavemang2 ай бұрын
White washer should have went under metal washer. Protects the china and gets a good grab. 2nd metal washer wasn't really needed.
@fixitjohn2 ай бұрын
Ok thanks
@CP-nf9my18 күн бұрын
They make plastic shims. Caulk isn't a very good shim.
@fixitjohn18 күн бұрын
@@CP-nf9my Thanks for mentioning that will help someone who reads this comment. I have used composite shims. I think that I said something about that in the video. Thank you for sharing.