Understanding Sequence of Army Firing Positions for Rifle Qualification

Рет қаралды 40,363

2 жыл бұрын

Master Sgt. Constantino Natale, the Rhode Island National Guard Marksmanship Training Coordinator, Small Arms Readiness Training Section instructor, provides instruction on the sequence of firing positions during the Army’s new rifle and carbine weapon qualification. More information on the Army’s new weapon qualification can be found in the TC 3-20.4.

Пікірлер: 26

@rebelthrukansas0 3 ай бұрын

Still remember my 40/40 range score, ds and range officer were in disbelief and made me do it again. After a second 40/40 the ro challenged me to a long range shot, with iron sights I made it to 500 yards but the ro did 600 yards and I had to do pushups till everyone else was done. Moral of the story if you are good, don’t show it unless you need some apft training on your arms.

@DirtyBeatzMusic 2 ай бұрын

thats a good story brother. tell it often

@Sauce_Ricky Жыл бұрын

Quality Series! It’s good to see experience on social media

@VanZeig Жыл бұрын

Great video, thank you for taking time to explain this 🙌🏾

@iwillwait7 3 ай бұрын

Great video I am about to go qualify tomorrow. Brushing up on the different positions in sequence. Thanks again!

@badbunny3147 Жыл бұрын

Great video 👍👍

@johnmorganjr769 4 ай бұрын

Yes! Thank you! Support on magazine made me more accurate as well (When permitted). 🇺🇸

@zingacha9133 Жыл бұрын

Yo the 2 knees for kneeling is a game changer ty!

@CrusadingCanis97 4 ай бұрын

I've honestly never considered this... I need to rethink my life

@likeprincetj Жыл бұрын

I hate using iron sites because it’s a lot harder for me to lock onto a target with it literally the first time they let us go the range with red dots I shot expert the first time

@edwinbaez5940 6 ай бұрын

Lol at my old unit we always skipped the practice round and went straight into the qual 😂

@Airmanmx1 Жыл бұрын

PSA, please remove any vertical grips during the evolution as it will hinder your mobility. The vertical grip will get caught on the barricade. You should also never use it as a “bipod” at all unless it comes with one inside the grip.

@Justin-rq6kf 4 ай бұрын

Simply pay attention to your weapon and the barricade to avoid that.

@thraxberserker9960 3 ай бұрын

Why would I not use the grip to support the weapon?

@Airmanmx1 3 ай бұрын

@@Justin-rq6kf not everyone is articulate as you. Humble yourself a little. For the mere mortals like us it is best to remove unnecessary accessories to our weapon except you of course. Perhaps you should try for BUDS

@Airmanmx1 3 ай бұрын

@@thraxberserker9960 the grip is too short to use in the prone position. Add the blockage from the ACH (will block your eyes). Technically using the inserted magazine into your weapon is considered prone unsupported which is longer than the front grip. Try it and let me know what you have discovered. Let’s talk about it

@Justin-rq6kf 3 ай бұрын

@@Airmanmx1 Plenty of people who aren't Navy Seals can run a vertical grip without major issues, I think something might be wrong with you.

@jrose2dzl Жыл бұрын

Wait it's not a myth, it's definitely a chance but especially dropping down and letting the MAg slam the dirt or catching all that recoil can and does loosen your lower where the mag goes in, happen very bad to my 10/22 and now I get jam after jam because the bullet is being fed usually pointing higher than the barrel meaning I'm applying a pull pressure on the mag

@superfamilyallosauridae6505 10 ай бұрын

a ruger 10/22 is an immensely more fragile firearm than an M4 carbine or M16

@skyofstorms 8 ай бұрын

10/22 with a banana mag and an m4 are not even close in comparison lol

@baronc252 7 ай бұрын

Hahahaha no it won't jam guy. I've been qualifying with the mag on the ground for the last 12 years. Your 22 is not a fighting rifle. 22 rifles are notorious for being hot garbage all by themselves. Dude in the video is right. It's a myth

@kevinallies1014 7 ай бұрын

@jrose2dzl The AR/M-4/M16 lower is a single piece billet. There is no magazine that is going to brand that billet. You might damage the magazine catch over time which is likely the problem with your 10/22. Also check the magazine itself since 10/22 mags are plastic. You may have damaged the catches at the top of the magazine which keeps the rounds down. You can probably bend them back down. AR mags don’t have those and the chance of damaging feed lips is very low without significant usage (we’re talking thousands of rounds).

@sldessel 4 ай бұрын

It is not a "Myth" about using the magazine to support the rifle will cause a malfunction. This "At one time" was a "Slight Problem". They have redesigned the mags and redesigned the mag well to prevent this. On some old model mags and older AR platforms, if you applied too much upwards pressure on your mag it would move up into the path of the bolt and cause a bolt lock. This is also a problem with magazine fed handgunds. Some people will "SMASH" the magazine into the mag well and put the mag into the path of the upper slide. This problem does not happen very often so telling shooter to not worry about it is a good thing. You are better off shooting supported by the magazine then to worry about this problem..

@LRRPFco52 3 ай бұрын

It isn't physically possible to push past the magazine catch limits and bolt carrier rails/feed lip interface with the M4/M16, unless you have seriously-damaged mags. I used to use magazine monopod even with black and green follower mags in the 1990s and early 2000s when doing the old qual. I was SOTIC/Sniper trained, so I did my own thing and taught my guys how to actually shoot.