Understanding Transformer Testing

Рет қаралды 16,304

Күн бұрын

This video provides a short technical overview of the most common transformer measurements and how these measurements are made.
Learn more about the R&S LCX LCR meter: rsna.us/6057wgG3f
Timeline:
00:00 Introduction
00:12 Suggested Viewing
00:27 About transformers
01:20 Transformer construction
02:01 About transformer testing
02:40 Common transformer measurements
03:08 Turns ratio
03:49 About mutual inductance (M)
04:48 About phase angle
05:23 Measuring phase angle
05:48 About primary and secondary inductance
06:21 Turns ratio from primary and secondary inductance
07:10 About leakage inductance - ideal transformer
07:40 About leakage inductance - real transformer
08:30 Measuring leakage inductance
09:15 Summary

Пікірлер: 9

@ChrisSmith-tc4df Жыл бұрын

As a practical matter, I would have described the primary as the driven winding as secondaries are typically wound atop it for the best coupling.

@pauldenisowski 5 ай бұрын

Yes, agreed, but it's a lot harder to illustrate :) Thanks!

@remontlive 2 жыл бұрын

Great explanation 👍🏼👍🏼👍🏼

@pauldenisowski 2 жыл бұрын

Большое спасибо!

@asif1300 11 күн бұрын

Sir if i short secondary side and measures in primary side by LCR meter then it is leakage inductance of primary side OR overall leakage inductance referred to primary side??

@boim9312 2 жыл бұрын

Emang real non-Z, but we're not real function. Lol, great explanation 👍

@pauldenisowski 2 жыл бұрын

Thanks! :)

@waterfuel 2 жыл бұрын

Why is there loss of 14v from hand wound toroid transformer output with separate winds on core not overlapping. The frequency of primary was matched to source AC, the primary and secondary windings are in same direction and entire ring core is covered with wire , but 2 separate sides. I thought the core under Primary caused induction into separate secondary windings. Desparate.