How do you control your A/C?

@@edgarcia7153 physical knobs

Yep and that’s what I did. No major issues and it’s way better than that factory uconnect system.

I’m not sure to #1 but question 2 is for sure no

Plug and play for back up camera. I’d go with 8 cord 8gb ram or 4gb. I have the 2gb due to it being cheapest it isn’t bad at all but sometimes slow.

Did you end up installing a backup camera? I have this head unit and want to install an aftermarket backup camera

No, some are still available from the cluster though like the “time lights stay on after shutting door” etc

I'd like to know myself

No direct plug n play. I responded to your other comment with the specifics. Good luck brotha!

Not sure, I turned off the park sense. Used to drive me nuts.

It just the button you switched off under your climate control? Or you took out the module? Are you able to test it is what I am asking.

@@cjppedersen yes I can check for you later and get back to you

@@cjppedersen sorry it took so long everything is still working yes

@@Letsdoittv67 Thanks will be purchasing.

It could be defective. Try unplugging and replugging in, check all connections and make sure nothing is loose. Did you disconnect battery during install? If not you could of sent a static charge, I think that’s what it’s called, but you get what I mean and that can shock the board causing a resistor to fail. Try checking everything, no good I’d suggest sending back.

Hey, did you ever figure this out? When I installed my new one, I had the exact same issue. It was the canbus attachment (little red box that’s sorta clear)

I don’t think it would make a difference but you just never know. Can always keep your stock system incase things go wrong. What year is your truck?

“Cp link” app

I don’t have an actual fix, but I close all apps out and click “reboot” or “restart system” and usually it’ll help fine when it connects for a few days or so.

@@Letsdoittv67 where do I find the reboot or reset system?

@@peterhuang7148 in some models you pull the screen down and select reboot, in other models it’s in settings > system > restart system or reboot

Check all your included wires. I’ve had 3 of these in dash aftermarket upgrades (not replacing, they hold up nicely, just kept upgrading) and on each model it was a yellow wire or yellow wire adapter + a cord that is basically a USB-A type. Remember the old school wire that was on the ps3 controller and also on older mp3 players and some phones. That one. You need both plugged in, one is for power other is for video.

I know for sure I did not plug in that “Camera type plug” as I couldn’t find a plug for it. I’m gonna have to double check it one evening this week. Thanks again.

I’m going to be pretty useless here, I do believe I saw a red/white hookup on the back but I could be wrong. I’d suggest going with the slightly higher end model if you purchase, and I do believe the Amazon links show full picture of back and front.

Sub rca and 4 4 speaker rca’s just hooked up mine

@@ronnybray5175 I believe it was RA2 unit. 5 inch Sirius xm Bluetooth am fm head unit. The small with 2 dials for tune and volume

No just manual controls

No, I never did get it to work. I most likely missed something in the instruction manual. I have the upgraded version now with 8 cores 4 GB ram. It also has OLED instead of LCD.

@@Letsdoittv67 do u have the link for the stereo

@@jaimemoreno2532 check description of this video and new video, I’d suggest the newer one over this one.

No splice involved sir. Just connect it as if it were factory unit. You do have to mess with the yellow adapter (video cable)

@@Letsdoittv67 our screens look identical but I don’t believe I have that option. Did you post an install video? I’m just curious if I have all the same plugs. Or do you remember what was needed to do to modify the yellow adapter?

@@joshsummers1280 were you able to figure it out? I don’t have a full install video I also had to go behind my work the first time. There was an accessories bag and one of them converts the signal to another wire on the harness.

@@joshsummers1280 yellow cable should even say R. Cam or similar on it and another wire that is a type A usb, same as the ps3 controllers used to have and old mp3 players.

I’m thinking my set up must be different. I have the mini usb, but it’s goes to a 4 pin connector. And no yellow r-cam. I’m thinking I have to splice :/

Ignore my original comment, I deleted it. I didn’t end up keeping this unit installed, the only issue it ever had was volume and used to drive me nuts. It would go up and down on its own, probably just a defective unit, but I got the 4gb model now with OLED and it’s great. Same company I believe. Check my channel for the updated one.

2020 but it’s a classic (09-18 body style)

I upgraded. Same brand, but 4gb ram model with 1080p instead of 720p. I strongly believe it would still be working. The main issue that drove me crazy was the volume was moving on its own however it was probably a factory defect.

Does the back up camera still work

No it was plug and play. I believe this is only for the 7 speed fan models that have RA1 or RA2 radios, so you’ll need to move the ac control module to the new face plate. It was super easy took about 25 minutes to compete the entire thing.

What's RA 1 and 2 radio I currently have a 5.0 uconnect

@@mikeadair2363 the 5.0 is RA2 I believe. That’s what I had in my truck from factory was the 5.0 inch UConnect screen

You've been a great help thanks so much By the way your presentation was excellent Hope to order and install mine soon

Also did USB outlets still usable in the flip up console or do you have to reroute it?

The classic yes

Yes. Mine is a 20 warlock in video.

Has to be the manual dials for ac control not the dual climate

Perfect it should work ! I will order it soon. Thanks mate much appreciated

I have another video on my channel showing how to do it

@@Letsdoittv67 which one? I don’t see it

2013-2018 (2019-2024 Classic also)

They do sell similar ones for 2009-2012 as well