We had the Ford Jubilee there. Although we had a heck of a time getting it setup after it was in for some hydraulic repairs a while ago Thanks for watching
Пікірлер: 46
@Nortekj4 жыл бұрын
Top link is supposed to be in the upper hole of rock shaft, that lower hole will only allow the implement to raise or lower so far, also check the draft control under the seat area it is a little lever that has only two positions, either pointing forward or backwards, but I really believe the problem is due to not using top hole of rock shaft which allows the draw bars to go maximum travel in both directions, up and down
@billstmaxx4 жыл бұрын
I suggested that the top link wasn’t in the right spot but he insisted it was
@terrysavage2745 Жыл бұрын
I set mine by driving left back tire on six in block. Set plow level. Top link 26 in.from center to center of pins.
@l.herbertswoager929 Жыл бұрын
You should put a lead additive in the gas it Lubricates the valve guides in oldFord flatbread
@alanmcclusky4 жыл бұрын
Has the three point got draft because it maybe set too high you have draft to set the height for plowing regards from the UK Draft also controls the three point hitch height along with the normal height control hope this explains properly
@nickwharton32344 жыл бұрын
Mby needs bit of wait on the back the linkage didn’t look straight at first hope get it going love the old tractors 🚜
@TrainboyRR4 жыл бұрын
i like the tractor
@joeshearer12474 жыл бұрын
I figured you would try out the new clutch.
@joneschaeffer4156 Жыл бұрын
You are getting to be a pro farmer bill
@316jd1403 жыл бұрын
A 8N has two levers to control the 3 point, the draft control and the position control. I'm sure the Jubilee does also. There should be a smaller lever below the seat, just above the other lever. If you have used it and have it adjusted, I'll apologize. But if not, it might need to be set.
@tonysadventures225 Жыл бұрын
Need to move your back strap to the top hole. I had the same problem and after I moved it up to top hole it went to turning the dirt like it's supposed to.
@joneschaeffer4156 Жыл бұрын
My temperature would be exploding tooooo
@MARKLOCKWOOD20124 жыл бұрын
Could stand on the back for ballast
@keltonwright74 жыл бұрын
What did you think of driving the 820? Do you know what year that 820 is? Pre 1958 by the dash. Does it still have pony start or has it been converted to electric start?
@simonworman7898 Жыл бұрын
I did'nt know of any tractor that had two leveling boxes? Most 3pt ploughs are RH cut!
@garyconlon31074 жыл бұрын
See the toplink the end that goes to the plow need to come off and the end need adjusted and then put it back on should work
@jtx-tube Жыл бұрын
Ampheres on Zero(0), shouldn't that be charging while running on the ford NAA?
@bushelfoot Жыл бұрын
Unhook the lift arms and see if they go down more. The arm should go almost to the axle.
@franwilson20973 жыл бұрын
plow shears
@kevinbutton45804 жыл бұрын
I guess its Boris turn to do some plowing 😂😂😂
@billstmaxx4 жыл бұрын
That would be super awesome. But it has no governor on it so it would be hard to keep a constant speed
@cyclebuster Жыл бұрын
Wow first time plowing?
@donvoll25804 жыл бұрын
Good day Interesting video. I was going to suggest new plough shares. What is with the fan being opposite way Thanks
@jasonkyler84442 жыл бұрын
You probably dont care but does someone know of a method to log back into an Instagram account..? I was stupid lost the password. I would appreciate any tricks you can give me!
@jasonkyler84442 жыл бұрын
@Dorian Shepard thanks for your reply. I found the site through google and im trying it out atm. Takes quite some time so I will get back to you later with my results.
@jasonkyler84442 жыл бұрын
@Dorian Shepard It worked and I finally got access to my account again. I am so happy! Thanks so much, you really help me out!
@dorianshepard64242 жыл бұрын
@Jason Kyler happy to help =)
@randyscott86604 жыл бұрын
Use your legs to steer the ford we use to do that all the time
@danz-ls4ce3 жыл бұрын
put down the coffee
@kurtkuipers94734 жыл бұрын
U no good job lots of hard worker done before myself I worked on Dairy Farm we had three thousand acres for field work so how was Iron Man doing haven't seen Iron Man for a while
@randyscott86604 жыл бұрын
To high a gear on the ford drop a gear and rev the engine move more air through the rad
@donvoll25804 жыл бұрын
Good day I thought he said he was in 2nd gear. That should have been right for tractor. Thanks
@masseydriverb35824 жыл бұрын
Looks like soil is too hard make up a weight block for the plough
@glenpetree56603 жыл бұрын
You need new plow shews
@fordguy20014 жыл бұрын
first
@FarmerRen4 жыл бұрын
New Gopro Hero 8 is out.......
@johndeere7094 жыл бұрын
take the 2 sod cutters off or raise them up they are too low, not letting the plow all the way down.
@alexpaumen39374 жыл бұрын
The tractor my Grandfather has is much too big for this. It’s a 4440.
@pauleclemonsjr14574 жыл бұрын
Whats with that junky Canada flag lol
@jgigna4 жыл бұрын
Paul E Clemons Jr maybe it’s because he’s Canadian... hmm now there’s a thought huh
@billstmaxx4 жыл бұрын
I agree with that.
@pauleclemonsjr14574 жыл бұрын
@@billstmaxx what the junky canada part?
@kevinbutton45804 жыл бұрын
@@pauleclemonsjr1457 shhh go away no one wants to hear your ignorant ass