Bissell PowerClean Brushroll Bearings Replacement
Рет қаралды 3,149
Жыл бұрынTwo new 608Z bearings later and the curb find's brushroll is good to go for years. Stay tuned for other tests featuring this PowerClean.
@maryfarris4296 2 ай бұрын
You are a genius!!!!
@VacLab 2 ай бұрын
Ok, thanks!
@KirbyEnthusiast Жыл бұрын
Awesome upload Bill 👌👌👌
@awakenedlast 10 ай бұрын
I know this is somewhat old, but I just replaced the bearings in my roller as well. The one was completely seized, causing the belt to burn on the shaft of the motor, accompanied by a lovely burnt rubber exhaust. However, even after I verified it's free spinning, it seems like no matter the height I set it to, it still bogs down to a stop on carpet. I had to add small spacers to the housing around the roller to have less of the bristles touching. Has this happened to you?
@VacLab 10 ай бұрын
I've never experienced that with this machine. Did you install a new, tight belt?
@awakenedlast 10 ай бұрын
@@VacLab I did not. I'm not sure of the age of the belt (my mom asked me to look at it before she deemed it as "broken"), but it looked relatively in good condition and did require some stretch to fit the roller back in. It almost seems like the suction is so strong it lifts the carpet, making the height adjustment pointless.
@VacLab 10 ай бұрын
@@awakenedlast my Powerclean tested at 65CFM and 20" suction at the nozzle. So low suction.
@dann2ptf 7 ай бұрын
So, I noticed the bearings are labeled "608Z", but are actualy "608zz" since they have metal caps on both sides?
@VacLab 7 ай бұрын
608z and 608zz are the same. Metal end caps both sides.
@bigmesstest230 Жыл бұрын
Will there be a whole house vacuuming with that machine
@VacLab Жыл бұрын
At some point.
Bob Spurloc does stuff
Рет қаралды 21 М.
Skillbox Программирование
Рет қаралды 1 МЛН
Brother-live_mob
Рет қаралды 1,6 МЛН
Павел Хмурчик
Рет қаралды 133 М.
Тима Бичевский
Рет қаралды 1,1 МЛН