Good job ! Thanks for adjustment in car C7 for rot in 360+ 360= 720 .

An new at this and yr videos really helpful nicely done 👍

Thank you my friend you are a brave man

The best and the simpliest way to adjust the Valves with your self.....respect and many thanks for sharing your knowledge... Here in Greece mechanics dont tell you anything and try to make the job when you are not present.....😂Thats very bad and they are so small minded pure People

very good job sir

Good job friend

Good job

Những cơ khác có thể áp dụng chỉnh như thế này ko ta

Thanks man for the video, I didn't see injectors on 2 & 5 cylinders, is it part of the valve setti g exercise not to install those injectors? Kindly tell me. Thanks

Very informative

Where r u dear?

What is the firing order for C6.6 engine And how much I should set tappet in nm or kgs

I have a 235ci chevy engine that has a blown head gasket.... is it possible to pull the head and replace the gasket without pulling apart all the rockers and springs from the head. I know this question is a little off the purpose of your video but I'm guessing you would know.

Please i need your help If you dont mind.... My cotton picker smokes at low rpm i think grey smoke and in 2000rpm it works fine during the picking ... Is it possible to need Valve adjustment? I think that the diesel pump works good... The noise during low rpm is similar to rattle.... Thanks

I m the generator operator in pakistan plz firing order of gep 65_3 perkins olympian generator and how increase the rpm fuel pump delphi 1390

Thanks

Merci je suis mecanicin dieselise ,j'aime la mecanique

Annibody Tell Me the Firing Order of gep 65_3 plzzzzzzzxxzxzzzzzzzzzzzzzzzzz

D7 3T cat engine 19.60 model for valve gap settings

Saya mau mesin katerpilar,mau belajar stel klep,yang 6 silinder

what brand is that torque wrench ??? I need one to adjust my valves!

WAW WAW

Is this a caterpillar, isn't it the same as a caterpillar?

it's a shame you never mention "pinning" the flywheel for TDC for #1 & #6......that is very helpful in the real world when not working on a trainer....

Sorry, too much background noise.

Hi

C7

153-624

Please check there is something wrong, According to your method something missing on cylinder 3 and 4. 3 is not completed and 4 inlet doing twice

Mukh mafih..