Hello Really sorry for the late reply - I ended up not doing the video, I have however kept photos of how I did this. Do you have a facebook page I could send them to?

Would it be possible to send me them please? I have done my wiring today the same as yours. Only struggled with the wire on the passenger side for my switch to feed my leds. I couldn't feed it through the piller. But I'll try again at the weekend. Thanks very much for the help.

I've posted my Email but it keeps being removed. Must go against KZfaq policy.

Hello Mark, Yes I will do the Video on both of these, Solar panels arrived the other day. It will prob be a few weeks though as I only have the weekends to do this :-) - Thanks for the support.

Hello this is a LWB all lights & solar connected to the leisure battery under the benches - you can see this in my other videos 🙂

I don't use a split charger as I find the solar set up I install later on will be enough! I did put a split charger in the first Vivaro - It's really easy to do, and you can run the cable under the seats to the drivers side and behind the panelling. I position my Leisure battery next to the rear wheel arch to the front, I have shown this in my last conversion which you can find here on KZfaq - Thanks for watching and your support

Hi Lee, depends on the appliances- and distance- I always run larger cables than the amp required. - I even changed the Fridge cable out after this video as I wanted extra security. LED lights are really low amps so not a big issue, they all get fused off at the back of the switchboard. The fridge goes straight back to the fuse box with a separate switch- I wouldn’t use the switch board for any high amps. Hope this helps.

Yes you can, it will be however a lot more expensive. - look at Van junkies or12 volt Planet