Robot man these videos are an international treasure. Thank you for all you do, including this one.

You really make the best DIY repair videos on Vespas! Thanks for it!

A superb vid. Really detailed and helpful. And as the Americans used to say at the height of Flower Power, "keep on truckin'"

Thank you Robot, I’m very new to all of this, I didn’t have the proper tool to remove the front wheel, I was unable to get the glove box opened so I did what I could do which was to remove the old cable at the wheel and snake the cable up through the fender, up and up until I reach the speedometer itself, it works, now watching your video and listening to you was my guide on this, not a better way, it was the only way available for me under these circumstances.

Thanks again robot, great video as always! 4 people clicked thumbs down ... how could anyone find something negative about these quality clips? Padres haters?

Fantastic video! I have to replace the speedo cable on my 2006 LX 150... hope the fitting on the back of the speedo unit is not broken... you made fixing it look easy. Thanks

I've had to do this twice on my S 150, which is of course very similar but slightly more intricate, and these instructions are as usual FAR better than anything else that has been done online. To avoid any mistakes when running the new cable, I have found it easiest to tape the old one to a length of 12-gauge wire, pull it out (thus replacing the old cable with the wire), then use the wire to pull the new cable through. It is a tight squeeze through the fender, almost impossible-looking at first, but a few squirts of silicone spray help get it through. The fittings are too large to allow you to just tape the new cable to the old one. For as fragile as these cables are, it's odd how little lubrication there is on the length of the cable. I wish I'd added some as you did here.

Thanks, got the parts from you months ago, finally got around to doing the work. ET2-50, cable had locked up, which killed the plastic driven gear. I'd ordered both, and it did the trick. Thanks for the great vid. Oh, and I used sokme Aerospace 303 Protectant to lube the cable and rubber and plastic bits for routing. Side benefit, it's good for the plastics.

As always, a great video. Your videos have really helped me work on my scooter. Great job! Thanks!

Thanks for this gr8 guide! Changed: speedo cable, head light bulb, clock battery and front brake fluids of my new Vespa 125 LX 2006. All done 😅

You rock my friend! A fantastic walk-through of exactly what I needed to do

Great video - thanks for posting….so helpful 🙌🏻

Thanks mate never thought i could do it was looking for someone to fix mine and over where I live very hard to find but with you help I did it you the best mate thanks

Always the best video ! Thanks

Great video . This will make life an awful lot easier as i've one to do tomorrow. Cheers

This guy is so great. Keep them Videos comming

Mate you are very easy to listen to. Ur very helpful. I’m in Australia but you have all the knowledge. Thabk you. Ur so handy as I have 2 vespers to restore

thank you, i changed my cable today and your tutorial was very helpful

Super usefull, after a dorment winter i decided to take out my LX and found that my speed was a constant zero. The worm gear was chewed up also the tip of the accelerator cable broken because of bad grease, it was solid. I also found the problem to why nu glove box does not open, the latch was bent. I don' t know If the latch will handle my effort to bend IT back though

Great vid!

Job done! Thanks for helping me

super video um die tachowelle bei einer vespa zu wechseln

Thank you buddy good job

given me the confidence to have a go.... thanks @robot

Thanks a lot!!! 🎉

Brilliant! Thanks Robot. I will try.

das ist mal gut erklärt bester Mann LG SEBASTIAN

Right no.1 vespa chainal thanks

When you change the speedometer cable, the instrument than counts the Kilometres the bike has driven is fixed also ? Btw very helpful video.

Hey Robot, thanks for all the videos. My speedo just stopped working, pulled the gear per your video and its mashed up. I had a shop replace it just 2 years/250miles ago, the grease is really sticky and gummed up. Do you have a how-to on re-greasing the whole hub? 2003 ET4 150. Thanks again!

Do you know if most newer scooters are electronical speedometers vs mechanical? I have a Kymco like 150 2019 and mine stopped working yesterday and ABS light came on as well. My next scooter will be a Vespa I’m hoping. We have a dealership here in town. Thanks for all your videos. I’ve watched quite a few, even though I don’t own a Vespa.

i like to know how to recompiled the carburetor it lml 125cc auto stella

Hello Sir, I would like to know did Speed Sensor for vespa Sprint 2016 can be used by primavera year 2014?

how can take out the carburetor 2014 LML auto 125cc Stella

i wonder what makes the speedometer on LX 125 (2013) easly broke. mine have been replace 18 months ago, and now it broke again and i have to replace it with the new one

I like the LX left and right turn signal under the motorcycle handlebar, where can I buy it? how much does it cost to send, I am in Indonesia, thank you for this good article

Thanks for the detailed video. My Vespa ET4 150 2001 just broke the cable. The shop Cycle sports Vespa is to work on it tomorrow. How much will that be?😳🤔😔. My Vespa only has 6,400 miles🥹👌🏼🌺🙋🏻🙏🏼

Great video! Thanks very much for the help. I am in Australia, do you guys post to here? I need to buy a speedometer cable for my 2006 LX 125 Vespa so thought I would get it from you guys. Also I replaced my front brake pads and brake fluid for the first time. Was tough but got through it.. but in the process I managed to thread the nut on the bleeder nipple of my caliper pretty badly. It's the original caliper, just wondering if you sell the individual nipple/nut for it. Anyway thanks again for your videos, super helpful!

Robot is it possible to Retrofit a digital speedo option?

Would this solution also work for a BV250?

Hi Robot.... i have gts 300 from 2013. I want to change it to the 2015 speed meter,but this one the cable go straight in meter but th 2015 that doesnt go there.... my question is...is it posible to put the 2015 speedometer

Salam dari Indonesia.....

Hi, my speedometer on my Vespa Sprint 1969 is not working. I’ve replace the ‘spinner’ at the front wheel which didn’t help. Have you made a video on this model? Nice Channel btw 🙂

Changed mine on GTS, turns out that new cable head is too big to pass through the small hole on the fork. I guess that is why the old design can be dissemble, I end up remove front wheel and loose front shock just to replace that cable.

I have a vespa px 125, my speedometer cable and gear broke at 20k km, i replaced both the cable and the plastic gear. 10 km after the replacement, the main gear on the hub basically "ate" the plastic gear. I replaced it again, and it broke again... I don't understand why it continuous happening, it's kinda frustrating..

Does this fix the mileage meter as well

Would this be similar for a 2018 vespa gts 300? i'm struggling to find the part here in the UK

Sou fam da Vespa pífio.

Why is the speedometer on the Primavera 150 so inaccurate? I didn't realize that it's probably been that way since I bought it new in 2021. I'm never sure how fast I'm going.

How is the thing called at 22:50? i thought to replace my cable however i figured the previous owner destroyed this thing you´re talking about, can´t seem to find it anywhere. If anyone knows please let me know

Video is 3 yo but I got those same shoes!!! Oh yea and same Vespa issue 🤣

I sent you a message hopefully hear from you soon

Seems a lot of work just to change a speedo cable?

Chetak scooter

hanging the caliper in the air..big no no